(800) 853-2651
SHOP NOW

Recent content by 12shortcut

Yesterday's Tractor Forums
  1. 1

    Issue with correct front wheel bearing seals

    Where does the seal achieve its seal? On the smooth horizontal surface of the spindle just beyond the inner race shoulder? or the smooth vertical surface yet more inward? I just replaced the front wheel bearings on my 52-8N. Actually the right side so far. Got kits to do it. As I was...
  2. 1

    Eastern Wa.?

    Clarkston: 52 8N Used to be my Dad's back in MN.
  3. 1

    8N Governor: New, overspeeding

    I am having trouble getting a new (aftermarket) governor to adjust properly. It either over-speeds the engine when the throttle is at the top of the quadrant, or, by adjusting the limiter screw to prevent over-speeding I am left with about 1" of travel on the throttle quadrant (from Idle to...
  4. 1

    8N hydraulic lift control after rebuild

    BTW, the position of the four bolts securing the Touch Control Lever appear to be moved rearward to the point of being against the Ram Arm Housing.
  5. 1

    8N hydraulic lift control after rebuild

    The position/draft control lever is "up." The lift arms are connected to an implement (a pallet lift) at about one foot above the ground. I have not done any adjustments yet. I still have the dipstick cover off and can observe the movements (tractor not running). (1) With the...
  6. 1

    8N hydraulic lift control after rebuild

    I am finishing replacing the parts after rebuilding my hydraulics on an 8N. I installed a new cylinder and NAA piston. I also replaced all 4 valve assemblies in the pump. I put the top cover in place and torqued it down. I lifted the pump assembly into place, left the bolts finger tight and...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top