(800) 853-2651
SHOP NOW

Recent content by 135 guy

Yesterday's Tractor Forums
  1. 1

    Power steering fluid pumping out the steering column on Ferguson MF35 Diesel

    Tim: I had a similar thing happen on my MF 135. What happens is over time the seal wears the steering shaft enough that it will no longer seal especially as everything heats up. The solution to this is to install an SKF Speedi-Sleeve which is a very thin sleeve you install where the seal runs...
  2. 1

    Little Known War Heroes

    I am really sorry now that I posted this. I should have checked the information before I did. It was something my wife passed onto me from a veteran she works with. After Fawteen comment, I looked up the information and Bob Keeshan was in the service but never served overseas. Mr. Rogers was...
  3. 1

    Little Known War Heroes

    A friend of my wife who is in the Honor Guard passed this on to her. It is a testament to the heroes in our midst who went about their lives without wanting any recognition for what they had done in an earlier life. . For those who were not aware of what they did in the war. You Would Never...
  4. 1

    Non draft control top link pin (a)

    I posted a picture of that bracket and its dimensions two years ago. Do a search on this forum of "Dearborn sickle mower" and from the list of topics it brings up look under the 4/21/11 date and you will find the pictures if you wish to make one yourself. By the way, they appear to be cast...
  5. 1

    Front axle of MF150 adapt to a MF135

    I have a MF135 and would like to use a front-end loader on it. I have the swept back axle which is not the best for strength. Can one adapt the MF-150 axle and support to the MF135 and still use the hood and other front end sheet metal parts to adapt to the 150 axle support or are they too...
  6. 1

    Response for Mr. T. Minnesota

    The problem you see with your one front wheel being closer to the spindle arm is due to the wheelbearing nut not being tight enough so that the rear wheel bearing turns on the spindle shaft and wears it. This causes the wheel to creep in towards the Spindle arm. My brother and I both have...
  7. 1

    Oil or Grease in Steering Box

    The tractor is a 1973 U.S version MF-135 with power steering. The seals on the arms that the steering tie rods attach to were leaking. I took it apart to replace them and the cavity where the gears mesh had transmission type oil in it. In the I&T manual it says to fill it with 2 pints of...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top