(800) 853-2651
SHOP NOW

Recent content by 22 Massey

Yesterday's Tractor Forums
  1. 2

    Cockshutt 415 mower

    I have the cockshutt 415 mower which is the same as the Oliver 415. Does anyone else find the left wheel is in the way when changing knives? Also has anyone replaced the single rock guards with the swather type double guards? If so was it a success? My ledger plates are getting worn plus I am...
  2. 2

    22 MH brake springs

    Thank you to everyone who responded. I found some on ebay where the shipping was somewhat reasonable. I will certainly be trying Diamond tractor parts first in the future tho.
  3. 2

    22 MH brake springs

    I tried that but these springs are pretty uncommon. Will be heading to the city tomorrow and check a few places there.
  4. 2

    22 MH brake springs

    Anyone in Canada have a source for the little one inch springs in the disc brakes on a 22? They are available thru Steiner and I don’t mind paying the $7.00 price per spring, but the $65.00 shipping fee seems a bit excessive just wondering if there is a Canadian source that anyone is aware of.
  5. 2

    Rear axle seals 22 Massey Harris

    Ok thank you for replying
  6. 2

    Rear axle seals 22 Massey Harris

    I have removed the hub and axle from my 22. I have the inner seal but there was some leakage right next to the wheel as well. It does seem that the outer bearing is lubricated by means of a grease zerk and the only way oil gets there is through the failure of the inner seal. Just wondering if I...
  7. 2

    22 Massey input shaft oil seal

    Thanks everyone for the help. Got her done.
  8. 2

    22 Massey input shaft oil seal

    How much preload do you put on the bearing? Thank you in advance for the reply.
  9. 2

    22 Massey input shaft oil seal

    Thank you for the reply. So this seal is the accessible without splitting the tractor? Google told me I had to split it but that didn’t seem right to me. Thank you for the reaponse. It would seem then that splitting the tractor isn’t necessary whichis what google told me. That didn’t make...
  10. 2

    22 Massey input shaft oil seal

    I have a 22 Massey Harris. It has an oil leak at the point where the input shaft enters the transmission. I have disconnected the drive shaft from the back of the tractor however I don’t know how to remove it from the transmission in order to remove and replace the seal. Has anyone tackled this job?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top