-
3
JD CAM BEARINGS
Thank You and yes I did find a service manual. Along with that I found folks like you who care about helping. Thanks again.- 3amach
- Post #1
- Forum: Tractor & Farm Talk
-
3
CAM BEARINGS 1957 JD 420C Crawler
Thanks Mike. I just now found the information in The Jhon Deere Service Manual. Thanks Again!- 3amach
- Post #1
- Forum: John Deere
-
3
CAM BEARINGS 1957 JD 420C Crawler
Tractor is a 1957 J D 420C 113.3 Crawler. HELP, I have a question about cam bearing installation. The rear bearing is 1 1/4" long & has an oil hole 3/16" from one end & 3/32" from that hole is a semi-circular cutout which is at the edge of the bearing. The block has an oil slot which is...- 3amach
- Thread
- Replies: 6
- Forum: John Deere
-
3
CAM BEARINGS 1957 JD 420C Crawler
Tractor is a 1957 J D 420C 113.3 Crawler. HELP, I have a question about cam bearing installation. The rear bearing is 1 1/4" long & has an oil hole 3/16" from one end & 3/32" from that hole is a semi-circular cutout which is at the edge of the bearing. The block has an oil slot which is...- 3amach
- Thread
- Replies: 0
- Forum: Restoration Processes
-
3
JD CAM BEARINGS
Tractor is a 1957 J D 420C 113.3 Crawler. HELP, I have a question about cam bearing installation. The rear bearing is 1 1/4" long & has an oil hole 3/16" from one end & 3/32" from that hole is a semi-circular cutout which is at the edge of the bearing. The block has an oil slot which is...- 3amach
- Thread
- Replies: 3
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy