(800) 853-2651
SHOP NOW

Recent content by 4020 tractor nut

Yesterday's Tractor Forums
  1. 4

    Starter issues.

    Thanks ! I'll try again tomorrow. Have a good weekend!
  2. 4

    Starter issues.

    Hi, I would have to agree. I'm watching the videos because I think my issue is minor. If I only have to remove the regulator housing and it is somewhat simple, Ok. Otherwise I'll have to see if I can find a qualified local shop to do the work. Thanks.
  3. 4

    Starter issues.

    Hi, Thanks for this information. Have you taken the regulator housing off the pump while the pump is on the tractor? I started doing that but it seemed like the regulator housing didn't want to come off easily. Thanks!
  4. 4

    Starter issues.

    Hi, The diagram helped and I found out that the longer end goes toward the spring. I tried reassembling and the parts didn’t go back in place. I removed them with a small magnet and I pulled out more parts than I put in. I cleaned those parts off and I think that I have to remove the end of the...
  5. 4

    Starter issues.

    Hi I appreciate your advice. When I start this machine I'm in the seat and have all implements on the ground. Thanks
  6. 4

    Starter issues.

    It did but would not turn over the starter consistently.
  7. 4

    Starter issues.

    Parts are below. Part in question is to the left of the screen. Screen is being held down by a pick.
  8. 4

    Starter issues.

    So I have discovered a nylon filter just in side the regulating valve where fuel enters. When the screen came out there was a spring and another small part. The part was sideways at the bottom of the screen. All parts were very dirty and gummed up. I don't know which way the small part goes. One...
  9. 4

    Starter issues.

    That's what I thought. Thanks!
  10. 4

    Starter issues.

    I was pretty sure I had the fuel shut off in the correct position. I agree it should be forward. I am probably going to have the pump rebuilt I have no fuel going through the pump..
  11. 4

    Starter issues.

    Hi,How do I know the run position? Is there a schematic?
  12. 4

    Ford backhoe ?.?

    I bought a well used Ford loader/backhoe. Unlucky for me because it never really worked after I bought. I fixed the starter issues but one that has me stumped is the injection pump. I don’t know how to check it before you buy but somehow try to make sure it works.
  13. 4

    Starter issues.

    Hi, I have a CAV pump.The fuel return lines are clear and disconnected. The lines to the injectors are disconnected as well. Injectors are out. I wanted to flush out the old fuel before putting in the new injectors. The starter button I put in works great and the starter works just fine. What...
  14. 4

    Starter issues.

    So, it’s finally warm. 70 today. I have replaced the fuel filters and wired a new starter button. I have new injectors to put in but I thought I would run some fuel through the injection pump before I put the injectors in. No fuel. I have fuel to the pump but none out of the pump. What is my...
  15. 4

    ford backhoe/loader tractor

    Thanks for the information! Greatly appreciated!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top