(800) 853-2651
SHOP NOW

Recent content by 41106

Yesterday's Tractor Forums
  1. 4

    John Deere B question

    Correct - it has 3 speed H/L
  2. 4

    John Deere B question

    So hypothetically, if a person has a B in the family and was considering pulling it dead weight only, what hp would you guess it would produce if it were an early styled B with the larger factory stroke, block bored to accept over the counter high compression 50 pistons, custom ground cam...
  3. 4

    Concrete cleaning

    Thanks all!! I think I'll try oven cleaner first and go from there.
  4. 4

    Concrete cleaning

    Off topic question, but hoping someone has a solution. My ol dog, which I fear is nearing the end of his road, had a stomach virus causing him to get sick on my polebarn floor several times as he was ill and recovering. Let's just say these stains make oil stains look good. Anyone have...
  5. 4

    John Deere B RPM

    Wanting to put an alternator on it and just wanted to make sure it turns quick enough to get it charging.
  6. 4

    John Deere B RPM

    Forgive me if I misunderstood, but if I follow you correctly, the fan shaft spins at 1.67 times HALF the engine rpm?
  7. 4

    John Deere B RPM

    Could anyone tell me if the fan shaft spins at the same RPM as the crankshaft, or is it reduced? Thank you in advance!
  8. 4

    Farmall M starter options

    My M is stroked and higher compression and starters just don't hold up very long. Is there a heavier starter from something else that fits it? Thank you
  9. 4

    Prairie Dog Hunting

    It is so much fun! I went near Sheridan WY near big horn mountains. Hoping to get back out there sometime soon.
  10. 4

    Vic S

    Thank you guys!
  11. 4

    Vic S

    Vic... you stated in previous post that you have spent a lot of time figuring out stock parts that fit into tractor engines to increase power. I'm wondering if you came up with anything for a H farmall? I have one I'd like to 3mph stock pull and deadweight pull. Would love to hear any...
  12. 4

    John Deere B tires

    Thanks guys!
  13. 4

    John Deere B tires

    Would 11.2 x 38 tires look proper on an unstyled B or what is recommended? Thank you.
  14. 4

    Going to Makinak (sp) island

    I 2nd suggestions on Frankenmuth, tawas, hartwick pines and then running down west side of the state on your return. However, I like to add that once you are in the upper peninsula, head north to tequamana (sp) falls and then a little north and west to grand Marais and munising area. Town is...
  15. 4

    Farmall H 9 bolt hubs

    What tractors 9 bolt hubs fit a H farmall? Thank you.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top