Recent content by 420Ron

  1. 4

    Oil filter canister housing

    Found them thank you, I usually buy from same places, Just needed to look in other places . Thanks so much,Ron
  2. 4

    Oil filter canister housing

    I have the numbers for the parts, but unable to find them anywhere., with the exception bottom plate.
  3. 4

    Oil filter canister housing

    When I dismantled the oil filter assembly , I found the only inner hardware was the bottom plate seal . The top plate , washers and spring wasn't used by the original owner. I can only find the bottom plate seal replacement, the other hardware isn't offered . This has me wondering if using just...
  4. 4

    JD radiator engine painting

    The rustoleum paint is rated for 200 degrees, Would it work on a JD 420 w ? I don't think it would get that hot. Any information on this issue would be appreciated.
  5. 4

    Spring inside shift lever housing

    That's what I thought, is it to keep play in the lever to a minimum? The dirt inside was above the boot and probably was doing what the spring would do.
  6. 4

    Spring inside shift lever housing

    I'm restoring a 420w , I removed the shift lever housing and found a spring with one end broken off. Looked in all my manuals, show spring but not how it's attached. I'm thinking it goes around the shift lever and both ends attach to housing outside. Am I correct? Thank you for your...
  7. 4

    Torque

    Thank you, I was hoping the actual recommended torque was in a manual. I have a owners manual, service, and parts manual.
  8. 4

    Torque

    Torque recommended for the two 11/16 nuts on top of the valve cover on a 420 w ? Replacing the gasket, and any suggestions would be appreciated.
  9. 4

    Oil pan bolt torque

    Thanks gentlemen,Ron
  10. 4

    Oil pan bolt torque

    I'm replacing the oil pan gasket on my 1957 JD 420W. I have purchased every manual , parts numbers, service manuals and have the original owners manual. I'm searching for information on the oil pan bolt torque. Thank you for your consideration,Ron
  11. 4

    JD part number m4006t

    Sorry the assembly that I need for my 1957 420w ( m4006t and shaft & bushings) to replace broken assembly. Too many parts to remember, thank you for your consideration.Ron
  12. 4

    1957 420W axle pivot assembly

    Looking for part number T1824jd and shafts & bushings to restore a broken assembly. Thank you for your consideration,Ron
  13. 4

    JD 420W touch o matic front cover

    I'm installing a front cover ( m3245T ) . Need help with determining proper alignment of the arm on the touch o matic shaft inside the cover . Thank you for your consideration,Ron
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top