(800) 853-2651
SHOP NOW

Recent content by 47fivewindow

Yesterday's Tractor Forums
  1. 47fivewindow

    Cub PTO grinds rather than engages

    I am reading that the pto never actually gets in gear. It is usually the little pin in the shifter that moves the gear that locks the two shafts together is worn. You will need to pull the rear transmission cover to provide access to the shifter. Some here have welded drill bits to replace the...
  2. 47fivewindow

    3000 dash board

    A new steering wheel and some paint is in the plan. Next job is replacing the pto seal.
  3. 47fivewindow

    3000 dash board

    Head lights or headlines and rear flashing lights
  4. 47fivewindow

    House full of mosquito

    Out at the shop we have a couple 5 gal buckets with stale water and these dunks. The females lay their eggs in the water and the larva die. It has lead to a great reduction in mosquitos. Of course it has been dry here so they don't have a lot of other areas to breed. One dunk lasts about a...
  5. 47fivewindow

    48 cub carberator

    Every Cub I remember back firing had the order mixed up. Clockwise rotation of the rotor looking at it from the cap side. 1342 counting from the radiator. I have heard of very old plug wires cross firing. A crack or carbon trace in the cap? Hope that helps
  6. 47fivewindow

    3000 dash board

    I had the wrong alternator, the drive was gone and the gas level sending unit is bad. I don’t need the tach or fuel gauge. I had an abandoned boat on the property so I used the gages and sending units. It’s not correct but I’m happy.
  7. 47fivewindow

    '47 Cub governor adjustment advice

    That looks like you're not the first one to try to fix this. Time to punt. Install the used one.
  8. 47fivewindow

    Woods mower blades

    L59 C was for a Cub and yes they had an opposite rotation. Some one may have adapted it to your C
  9. 47fivewindow

    Looking at a Ford 3910, need some advice please…

    Yes 2wd with a 5 foot brush cutter. Too steep to go up or sideways. I had done it before when it was dry with no problem.
  10. 47fivewindow

    Looking at a Ford 3910, need some advice please…

    If you want to learn from my mistake, don't cut down the hill when the grass is covered with dew. Even though the tractor was was in a low gear the tires lost traction and away I went. I could still steer but was gaining speed all the way to the bottom. I was afraid I would roll if I got...
  11. 47fivewindow

    Im back

    Welcome back. I''m relived to hear it was only your electronics that were failing.
  12. 47fivewindow

    Is it plumb or is it level

    A lot of them are making it up as they go along. Never in a trade to learn the lingo. "You know, morrons"
  13. 47fivewindow

    Home made exhaust

    It had to take a long time for someone with that skill set. I had to admire it on that level.
  14. 47fivewindow

    Tuckahoe steam and gas show

    Aultman Taylor 30-60hp
  15. 47fivewindow

    Tuckahoe steam and gas show

    I didn't notice who made it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top