(800) 853-2651
SHOP NOW

Recent content by 510plows

Yesterday's Tractor Forums
  1. B

    Victor Head Gaket ?

    Does NAPA Sell Victor Head Gaskets, Need one for an H Farmall
  2. N

    1963 JD 2010 Left Rear Wheel Frozen?

    Curious if anyone has heard of this issue. Parked the JD in the Pole Barn in November without issue. Went out yesterday to move some snow. Tractor started just fine but would not move, only the right rear wheel would spin, but the left rear wheel is locked up. Not sure how this happens when...
  3. T

    John Deere Compact Loaders

    Will the bucket off a JD 40 loader fit a JD 70 loader.Have a 70 with a 5ft bucket on my 855 and want a 4ft bucket and have found a bucket at auction off a 40 loader.
  4. K

    Memorial H Project - Transmission Countershaft Success

    Hello all - thought you would like to get an update on the transmission countershaft removal. The coupler nut suffered as well as the front shaft bearing, but we got the shaft out without too much carnage. I am going to replace the shaft due to the several heating cycles that it was subject to...
  5. D

    64 Ford 4000 - three point hitch stopped working

    Last week I was pulling up T-posts using a tool designed to pull up T-posts, connected to a chain that was attached to boom that was operated by the three point hitch. This worked very well and it worked consistently for me, without issue. That was last week. Today, I needed to use the...
  6. D

    DPA pump question

    I have a 2424 with a DPA injector pump. Been running fine, but sudden no start condition. Replaced and bled fuel filter. I have fuel to the pump, but only a hint of fuel out of the lower bleeder on the pump body, and nothing out of the upper bleeder. My parts book shows a small filter inside the...
  7. jon f mn

    Today's Funny

    .
  8. D

    Flint Grey - Shine?

    Hi everyone, I've just sprayed the Float-a-matic seat from my 150 today in MF Vintage red for the seat pan and Flint Grey for the suspension frame etc. My normal thing for the last coat is around 80% thinners and 20 % paint to give the item a shine. I did this with the seat and it looks great...
  9. miner09

    Z134 Oil Filter

    Anyone having trouble with the oil rubber ring being a little to small.Hard to make it seal and not leak. Manufacturers have made it not as wide and diameter smaller. I've tried two different brands and are the same. Always used Wix but they have been changed also.Dealer even said they are...
  10. mikewood869

    John deere crawler parts

    Don't know if you guys are looking for parts. Maybe this isn't a John deere setup, don't know. https://newlondon.craigslist.org/grd/d/moosup-late-1950s-john-deer-bulldozer/6911943380.html
  11. J

    Anyone do antique engines? And a few of mine

    Figured a few of you fool with them. The stationary engine page on here is kind of dead. Well I just finished a Fairbanks ZD "salt block" Maytag twin and now working on an International LB. I was always fascinated by them, would like to hear your stories.
  12. C

    jd 160

    I picked this up at an action. it will run with the brake in. if you let the brake out it will stop running, what is going on? is there a wire I can unplug to by pass the safty switch? 16 hp auto
  13. A

    Mustang 440 skid steer

    Looking at a 440 mustang skid steer that is in rough condition. I do know that it is a hydrostatics drive and as the owner has said 4 years ago it ran great till there was a leaf fire in the radiator. Does anyone have experience with repowering these machines or how finding parts will be fore...
  14. L

    1206 third link

    I had a new 1965 1206 and it had the claw type third link.I have had many since and if they have one it is always the same on both ends.Was 1965 the only year that the claw was used I see them advertsed on the high side compared to ones I have Thanks
  15. 1

    Dc clutch question

    I have a 49 dc that has a hand clutch and I know that they made some later models with a foot clutch. My question is can I convert my hand clutch tractor to a foot clutch or is it more complicated than just swapping parts? All your help is much appreciated
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top