(800) 853-2651
SHOP NOW

Recent content by 5urv3y0r

Yesterday's Tractor Forums
  1. 5

    Massey 240 not starting

    Dieseltech, we removed the side cover on the pump and bumped the starter to find that the drive plate does spin. So, per your message above, the injector pump must be removed so i can be rebuilt. Yes?
  2. 5

    Massey 240 not starting

    Either way it doesn't sound good
  3. 5

    Massey 240 not starting

    Thanks for your knowledge. Will see what we can find out.
  4. 5

    Massey 240 not starting

    Thanks, standing by
  5. 5

    Massey 240 not starting

    OK, I won't tell you that, But, we just took it for another spin for about 3/4 of a mile and still nothing
  6. 5

    Massey 240 not starting

    @Dieseltech, at the suggestion of Jim.ME, we cranked the engine with the high pressure nuts loosened, no fuel to the injectors. We also towed the tractor for about a 1/4 mile (not sure whether we were to pull while in gear) to speed along the bleeding of air from the high pressure lines but to...
  7. 5

    Massey 240 not starting

    We had been cranking for between 30 seconds and a minute and still nothing. Keep going?
  8. 5

    MF 240 no fuel to injectors

    we have towed it for about 1/4 mile but still nothing. any suggestions?
  9. 5

    MF 240 no fuel to injectors

    We'll give that a shot and see if that helps get fuel to the injectors. Will let you know how that works
  10. 5

    MF 240 no fuel to injectors

    My apologies for jumping threads. The fuel shutoff is in the run position, throttle is set at half or better and we are cranking the engine with the starter but no fuel appearing at the high pressure nuts after 30 seconds or better of cranking
  11. 5

    MF 240 no fuel to injectors

    Dieseltech, I am having the same problem. The tractor had run as recent as 2 weeks ago and all of a sudden just stopped. Cleaned out the fuel tank as the valve had become filled with crud. Replaced the injectors and fuel lift pump. Installed new olives where needed and have bled the fuel lines...
  12. 5

    Massey 240 not starting

    Ok Jim.ME, I have bled the lines in the correct order and got fuel to run without bubbles. The only thing I am seeing now is no fuel emanating from the high pressure fuel lines leading to injectors 1 and 3. Where am I going wrong?
  13. 5

    Massey 240 not starting

    Is this what you are referring to?
  14. 5

    Massey 240 not starting

    Thank you for your post Dieseltech, can you share a photo of the right angle wrench you refer to? The clawfoot and stubby wrenches were a no-go. and the Harbor Freight angle head wrenches were sold as a set for $79. Too much to spend for needing only one size
  15. 5

    Massey 240 not starting

    Thanks gents!! Yes, they are a bear to get to with the tank installed and very little room to work the wrenches. Both options look viable. Heading to Harbor Freight in Hattiesburg now!!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top