(800) 853-2651
SHOP NOW

Recent content by 730DM4WD

Yesterday's Tractor Forums
  1. 7

    JD 830 , 820 three point

    And it would have to be 4 wheel drive.
  2. 7

    JD 830 , 820 three point

    They were never built with a three point hitch. I have heard rumours of an 830 where the three point hitch off a 730 had been fitted. I have often dreamed of doing this myself - but never got further than the dream. Could the entire back axle off a 730 be made to fit onto the 830 crankcase...
  3. 7

    2 cylinder ROPS

    4020 roll bar
  4. 7

    2 cylinder ROPS

    Dog basket - not laundry basket
  5. 7

    Sectioned views of a JD 60 cylinder head

    I want to put 830 valves in my 730 - I know that others have done this - but looking at these images I am concerned about breaking into water passages - I would be grateful for comments and thoughts.
  6. 7

    Fueling up

    These are the steps on the 730.
  7. 7

    Cup for best working tractor

    If I had found time to clean the tractor it would not have looked like a working tractor - and it would not have got cup for best working tractor
  8. 7

    Third attempt to load video

    <video width=90% src=https://www.yesterdaystractors.com/cvvideos/cvvideo133152.mov controls>http://forums.yesterdaystractors.com/cvvideos/cvvideo133152.mov</video>
  9. 7

    Too busy hay making

    Too busy hay making to clean tractor
  10. 7

    Too busy hay making to clean tractor

    No time to clean it down
  11. 7

    First show since 2019

    Went to show today - first since 2019
  12. 7

    what jd tractor you dont have but want ?

    Also with Hysler head, power block and twin venturis.
  13. 7

    what jd tractor you dont have but want ?

    Unstyled G with 6 speed gears with high ratio top gear, three point linkage, and Roadless M4WD axle on front
  14. 7

    Theres a dog

    I would really enjoy meeting Ringo. I am sure that he would enlighten me on the benefits of a straight six. Keira, my two cylinder dog refuses to wear ear defenders and has recently gone deaf.
  15. 7

    Theres a dog

    It was a row crop when I bought it - the toughest part of the 4WD conversion was connecting the bevel box to the lower shaft in the 730 transmission.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top