(800) 853-2651
SHOP NOW

Recent content by 744k

Yesterday's Tractor Forums
  1. 7

    Farmall super A starting problem

    I've read the entire post twice and nobody has mentioned anything about the float level, would this create a hard starting if there wasn't enough gas in the bowl. If you have good flow to the carb does that mean the fuel level is correct, just a thought.
  2. 7

    JD 50 idles and runs rough, revs up and down

    Should be a 1/2 hole short
  3. 7

    Posting a picture for the first time from my phone

    My first picture
  4. 7

    318

    Been a lot of trials and errors but think I found the problem, one of the stator wirers was rubbing the engine sheet metal. I suppose that sent battery voltage straight to ground?. Got everything back together with no arcing on the negative post,starts and runs like it did before
  5. 7

    318

    Bought a non running 318 b series engine serial # 363806. Changed carb,fuel tank,lines,was running like a new . First time I used it ,it would run mabey 10 minutes and die like you would have turned the key off,wait a few seconds and it would run ,it would do the same thing again. Used it the...
  6. 7

    2510 overhaul

    I was putting the after market liner in with the new rings and it slid in with no effort at all , the after market liner was 25 thousands to small
  7. 7

    2510 overhaul

    Guess u haven't read a tech manual
  8. 7

    2510 overhaul

    If he can find a tech manual it should give him all the dimensions. When I did my 4020 I found out after market liners are not all the same. My first liner I got would slide in with no resistance, the next liner I got from a&i had to use a block of wood and a hammer
  9. 7

    1982 John Deere 317

    I have a 318 that does the same thing. The pivot bolt is rusted so the axle won't pivot
  10. 7

    Center ramp for narrow front end

    I use a 12 inch wide by 3 inch bridge plank about 5 foot long with a angle bolted to one end so it won't slide off
  11. 7

    Gas tank swap

    The GTank is 2 1/2 inches wider than a A tank
  12. 7

    Confused on A vs B physical dimensions

    What are the dimensions of your door.
  13. 7

    46A loader on later two cylinders

    Aumann has a john deere 60 with a 48 mounted on it. It is on an auction in laredo Mo.
  14. 7

    Auction accuracy

    Looks like a 55 john deere
  15. 7

    What is it, tractor

    Looks like a RC
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top