(800) 853-2651
SHOP NOW

Recent content by 8v92guy

Yesterday's Tractor Forums
  1. 8

    Gravely 8123 lawntractor

    did this just happen or has it been this way since you have had the machine? Another poster mentioned stuck pto clutch and that can happen but the screwdriver threw the yoke trick only works if it slighty stuck most of the time it requires removal of the clutch.
  2. 8

    Gravely 8123 lawntractor

    never mind the pin or the two bolts. jeffcat is either taking about a 400 series or two wheel tractor what you have is an 8000 series totally different machine. if you look at the parts diagram ray posted you will see a snap ring on the engine side of the pto shaft if that breaks it will cause...
  3. 8

    Needing a 1980 brigadier door

    gm used the same basic cab from 1967-1988. 7500 series thru 9500 series and also brigadier. D you need a whole door or just guts?
  4. 8

    Pasquali Front Loader

    I have a loader we took off a 494 not sure if it would fit yours
  5. 8

    Rear wheel weights on Super-C

    that's right you didn't sat who or where. There is more folk from our club that go on this site than you may think. I do not want to argue with you. but calling a member of our club "to stupid to know the difference'' was a little over the top. you should listen to him and ask for advice rather...
  6. 8

    Rear wheel weights on Super-C

    hey pf calling fred stupid is uncalled for. He is one of the most resepctfull pullers I have ever pulled with. I was not there but he was not the only one who thought you were way heavy. just saying
  7. 8

    An interesting truck

    The gmc 702 does not have full length heads. it has 4 heads and 4 exhaust manifolds. the block is one piece. We have 4 of those engines.
  8. 8

    yanmar 226d / what model JD?

    basically the same as 750. but jd never hade the powershift trans. Parts are getting very hard to get for those old yanmars .
  9. 8

    6v53t Detroit parts needed

    I have a complete 6v53 for parts. not sure where you are but I am in ma.
  10. 8

    wheelie bars

    Does anyone have pictures of wheelie bars for a Minneapolis Moline gb. I have an idea how to build them but I would like to see how other folks have made them.
  11. 8

    Cliff Clark's pull

    no tire size rule. just no cut tires in ''stock'' classes
  12. 8

    Cliff Clark's pull

    saterday june 7th transfer sled pull. we will be pulling 3,500 lbs. up to 12,500lbs no cut tires in stock classes . I don't have the rules right in front of me at this time. Its a real good time at cliffs hope you can make it.
  13. 8

    BX2200 rear aux hydraulics

    jm is right not hard to install.
  14. 8

    Oliver diesel

    It might pull a little better but I think first place in 5000,5500 classes and 2nd place overall points for the season isn't bad. maybe if I had a oliver with super low gear it would be better :roll:
  15. 8

    Anybody ever forget to put their farmplate on?

    Gene, in ma. it is legal you just have to pay sales tax on vehicle's you are using and the state will give a compliance decal to put in back window. You can use plate on any vehicle that has decal. Also in ma. we have repair plates that are treated the same way we have two repair plates and ten...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top