Recent content by Aaroncboo1

  1. A

    Case 2290 pto rebuild

    Correct it's leaking from the splines and not the larger seal. I heard if you parked it on a hill it didn't drain that much oil out. It's crazy to think you have to pull that out just to change one o-ring
  2. A

    Case 2290 pto rebuild

    Yes it is dual speed. I'm thinking that it's that small O-ring is the culprit. Just a matter of if it can be replaced without removing the whole pto.
  3. A

    Case 2290 pto rebuild

    I have a case 2290 that is leaking oil from the pto shaft. I read somewhere that if if it's leaking from the seal them that's just what's needed to be replaced but if it's leaking from right by the pto shaft then you need to rebuild the pto to replace some O-rings that are in there. Has...
  4. H

    Opinions on forty series CCLS hydraulic problem

    We have here a 6640, typical dual pump system with dual deluxe remote valve body. Front end loader is operated by them, disconnected when remotes are needed for other things. Hydraulics gradually weakened, slow operation, finally almost no operation. The internal pump had been replaced about...
  5. A

    Case 2290 pto won't shut off

    So I had talked to an old time mechanic and he suggested turning the pto on then shutting the tractor off to see if it disengaged any easier. He said if the pto didn't slip he wouldn't think the clutches are bad, figure that if the pto disengaged while the tractor was off it would indicate...
  6. A

    Case 2290 pto won't shut off

    So it should just be able to push down to disengage at any point? No need to clutch it? I'm hoping to use it for round bales and my baler manual says to shut off the pto when dumping. Also know about the pto in reverse issues but I've read that's only an issue with the tractor in park and...
  7. A

    Case 2290 pto won't shut off

    It can be pulled on. And after a few minutes of messing with it I can get it to turn off.
  8. A

    Case 2290 no power

    Just an update. It works and I have no idea what I did. Must be a short somewhere. It might happen again but it may be a long time or 2 hrs. So I figure I'll run it like it is and then look in to it when I don't need it.
  9. A

    Case 2290 pto won't shut off

    I was cutting hay and when I got done I went to shut the pto off and couldn't. Took about 5 minutes of messing with it to shut it off. The knob lifts good to turn it on so I wouldn't think it would be stuck. Any ideas?
  10. A

    Case 2290 no power

    Circuit breakers are both good and I replaced the relay and harness. I have no power between the breaker and the fuse block. Trying to figure out what wire is what. Tech manual is helpful but wire colors don't always match up.
  11. A

    Case 2290 no power

    The ac had been retrofitted for the newer refrigerant that I'm drawing a blank on the name. But when I hook up the can with the gauge it goes straight to 100 on the dial. Don't know much about it but that was to high and I stopped messing with that. I'll check the switch for power today and see...
  12. A

    Case 2290 no power

    got the case 2290 home and have been working on electrical stuff like a new radio and speakers.Everything worked but the A/C. Had a couple of friends doing stuff to try and get power to the compressor because we had none. Well in the process of messing with it they ended up killing the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top