(800) 853-2651
SHOP NOW

Recent content by AC Tim

Yesterday's Tractor Forums
  1. A

    Cat D5B air in fuel lines

    Thanks AJ, I did all you said, and it is working great. Thanks Much
  2. A

    Cat D5B air in fuel lines

    Bob got it right. I had sediment blocking the fuel line from the tank. I stuck a wire through it and out came the dirty fuel. Put it back together and primed it, and it started up and ran perfect. i am going to put a new primer pump on it though, because of the leak. Thanks much for the help
  3. A

    Cat D5B air in fuel lines

    I should have added this additional info. I was grading, and it was running perfect, when I ran out of fuel. i filled up the tank, and primed the pump with the hand pump, and noticed it was leaking out of the piston on the pump when depressed (slightly, not a lot). Engine would start and run...
  4. A

    Cat D5B air in fuel lines

    I have air (very small bubbles almost like foam) when I crack the fuel lines. Fuel pressure is fine for 5 minutes, then it starts to drop. If I re-prime with the primer p hand pump, it starts back up, but does the same thing within minutes. I am thinking that the fuel primer pump is faulty...
  5. A

    69 Allis Chamlers

    Looks like an HD11. We have one and it has been very reliable and easy to work on. Injectors are no problem. the one area to look for is the final drive. Make sure everything there looks tight and minimal leakage. Check the final drive oil level. $8k seems fair if in decent shape.
  6. A

    AC HD-11

    I am out of San Antonio, Tx
  7. A

    AC HD-11

    Anyone know if the tracks from a TD15c will fit a 1960 HD11? Thanks
  8. A

    Aliis HD11 1959 model

    I have a leaking rear seal on my HD11. Has anyone done that type of repair, and any suggestions would be most appreciated. The dozer runs like a Swiss watch otherwise. The Best
  9. A

    Cat D5B Clutch adjustment

    Thanks again Bob, The manual was confusing to me. I got it adjusted and ready for a new project. Too much fun working on these machines and learning about them. The Best
  10. A

    Cat D5B Clutch adjustment

    Hi Bob, I cant find any ring that moves freely in the housing. Does it require a tool or wrench to move it? The Best
  11. A

    Cat D5B Clutch adjustment

    I have the manual for tightening the clutch on my dozer. I have removed the clutch inspection cover and loosened the 2 locknuts/retainer plates on the clutch. But the manual says to turn the adjusting ring to the right, but gives no description or location of the adjusting ring. Can someone...
  12. A

    Update Cat 3306 fuel pump

    Thanks Bob, It is running like a Swiss watch. I am all done for now. It was alot of fun learning how it works, and getting it working again. The Best
  13. A

    Update Cat 3306 fuel pump

    Yes it was froze. I replaced the whole plunger and spring mechanism. i am doing manual timing and going to get it close to get it back in the barn. First round I had a cold cylinder (not enough fuel pumping out of the piston ? ), second round very hot cylinder (too much fuel pumping ? )...
  14. A

    Update Cat 3306 fuel pump

    Pic of plunger sheared off. All other plunger were perfect. Weird?
  15. A

    Update Cat 3306 fuel pump

    Yes, I beleive you are right. I think the lever is not set correctly. It is the same cylinder that I had problems with before, however, at that time it had no fuel going to it because of the sheared off plunger. It is firing but not real hot. At full throttle it heats up a bit. I guess I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top