-
A
Ford 600 hydraulics
I chased lift problem on an 801 for a couple of months. Couldn't build more than 400 psi of pressure. Totally rebuilt the pump including the wobble plate at the rear as well as everything else. Cover on and off several times. I listened to everyone tell me it wasn't the relief valve. At the... -
A
3400 look-see
Its been 15 years; but my 67 3400, had the same "bad" feel taking off. Turns out the pinion shaft has a bearing on the back side, opposite the trans. Original bearing has a snap ring holding the rollers in. Snap ring had punched out but rollers were still in place. When you let out the...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy