(800) 853-2651
SHOP NOW

Recent content by aircrue

Yesterday's Tractor Forums
  1. A

    75 4000su rear rim size

    Hi All! I need a little help selecting the correct rims for my tractor, chloride has rotted the rims. The tires say: 16.9 - 24 On 15 Rim 14-24 The wheels have 6 loops and the hub has 8 lugs. Would I be correct in replacing with an 24x15 wheel? Thanks!
  2. A

    Ford 3000 Not Charging Battery

    My Generator failed on mine. It was much cheaper to swap with an alternator, and the added performance is a bonus.
  3. A

    3000 Steering Cylinder Bending

    My 4000su (3000 front end) was doing the same thing, my problem ended up being worn keyways on the spindle shafts. With a heavy front loader on it, I never felt play in the steering, but it was there. After swapping both spindles, all is well now.
  4. A

    Ford 3400 engine siezed?

    Did you try to turn the flywheel with a prybar when you had the starter out and trannie in neutral? I would think you'd have to raise both rear wheels to try to turn the engine? I would pull the pan also and check the main bearings for damage after ruling out other ways to turn the engine. I...
  5. A

    1970s ford 3400 Carb replacement?

    What are the symptoms you are having while running? I was having problems with mine, wouldn't start, would start but run rough, would start and run great for about a half hour and then quit. I swore up and down it was the Carb, almost ordered the Zenith to replace my Holley, then troubleshot 1...
  6. A

    Ford 3600 gas

    Was having a similar problem after about 30 mins of running, turned out to be two things. 1. filter had fallen off petcock inside gas tank and a beetle had gotten sucked into the petcock and was blocking half the fuel flow. 2. The coil which was only a year old was failing and had lost 1/2 of...
  7. A

    Ford 3000 Front End

    I had the issue also on mine. Wasted a day with heating and 8' long cheater bar. I ended up having to take the front support off and chopping out the pin with a bandsaw and had to cut the pin inside of the arm lengthwise and working it out that way so I didn't mess up the threads. Hope you have...
  8. A

    7710 series 2 not cranking

    I had the same problem last year, replaced the starter and solenoid only to find out that the ground wire was bad even though it looked almost new on the outside. Cut it open and found corrosion city.
  9. A

    Drawbar.

    Looks exactly like mine off of a 75 4000su.
  10. A

    Brake tubes.

    Lyle, Which model/year tractor do you have? I was able to change my brake seals on my 75 4000su from the outside.
  11. A

    Ford Rotary Cutter 22-50 blades

    Picked up this cutter in working condition for 100$ only thing missing is the rear diverter plate? Anyone know off hand the blade size? This thing is built like a tank.
  12. A

    GO BLUE....Ultradog says SO!!!

    Looking good! I just resto'd my 4000 this past winter/spring. It is an addiction! Looking at your pic, can you tell me what size those front tires are? I have Ag's on mine, hate them and want some treads like yours. Thanks!
  13. A

    4000 engine swap with 545D turbo?

    VanAlstine Truck in Sandusky, MI machined mine, did a fantastic quick job. Its a haul for you, but they might have the time?
  14. A

    Will this Engine fit a 3000 Diesel?

    Exactly what I was thinking, it would be a 4000su.
  15. A

    1975 Ford 2000 D power steering pump removal

    What Rick and Shaun said, two bolts on the shroud bolt through to the pump, the whole unit will come out. If you don't have a new gasket, rtv it up!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top