(800) 853-2651
SHOP NOW

Recent content by AJB-830

Yesterday's Tractor Forums
  1. A

    Spring work started early again this year

    Don, As you probably know, it's just the opposite for us here in NE Wisconsin. 20+ inches of snow 2 weeks ago and 5 inches of rain last Saturday. It will be a couple of weeks before we can start spring planting, if we don't get any more rain. Al
  2. A

    Another try on JD plow.

    I looked at my JD 55 parts book this morning. The plow in question is definitely a JD 55 plow made between 1938 and 1945. The parts book shows a picture of that plow with the bar in the angle position that is shown in the original posted picture. In 1945 to 1960, the plow book shows the bar...
  3. A

    FARMALL H WITH CULTIVATORS PICS.

    Mike, I am not sure I still have all the parts for my HM-221 Cultivator. A few years ago I kind of took it apart. I sold one of the cylinders to a person who needed one for an IH mower. Might be more work trying to put it back together than it's worth. But it could be used for parts if you...
  4. A

    FARMALL H WITH CULTIVATORS PICS.

    Apparently my dad didn't have an operator's manual for the cultivator. But I believe it is an IH HM-221 steerable cultivator with the hydraulic lift. Back in the day my dad had 2 Hs. One he kept the cultivator on and the other had our IH 120 mower. That way we never had to remove them. I...
  5. A

    FARMALL H WITH CULTIVATORS PICS.

    Attached is a picture of my H Farmall when it had the cultivator attached. Probably taken around 1970. I still have the cultivators and possibly could find the pin you are looking for. Probably have to wait till spring to find it as the cultivators are covered in snow at this time. We used...
  6. A

    Happy Thanksgiving

    Hi Don, Hope you had a great Thanksgiving. I need to send you an email on my activities the last couple of months. Al
  7. A

    John Deere F650 three bottom plow

    I measured the lift rod on my 555 3-16 plow today. It measured 55 inches. The last 6 inches is threaded. I looked at my F620 4-16 plow too. Not sure you can just use a shorter lift rod. My F620 has the lift rod on a bracket welded to to land wheel. On my 555 the rod is connected to a...
  8. A

    John Deere F650 three bottom plow

    I have a JD 3-16 555 3-bottom plow. I also have an F620 4-16 4-bottom plow which is basically the same as your F640. I could measure the lift arm on my 3-bottom 16 inch 555 plow. But if you have a 14" plow, I think the arm might be shorter. Let me know if you have a 4-16 and I will measure...
  9. A

    Help Identifying Plow

    Could you post a picture? I have a 555, a 66, and an F620. The 666 is the heavy duty version and it does have the 6-bolt wheels. A picture would confirm what you have. Al
  10. A

    Help Identifying Sickle Mower

    I have the same 100 series IH balanced head mower mounted on an H. Mine still has the decal saying 120. I think the 120 is the version that mounts on a tractor draw bar. It was mounted on the H about 40 years ago and never taken off. Attached is a picture showing 120 decal on the balance head.
  11. A

    Combine for a smaller farm

    Back in 2010 I bought a JD 4420 combine with a 213 header for my hobby farm. Reason I bought the 4420 was that it was at my local JD dealer, was owned by local farmer who owned it for 18 years, it had only 3200 hours, and was always in a shed. At the time it was the largest combine with an...
  12. A

    Farmall Super MTA - Hydraulics - Where to begin?

    You might need to prime the hydraulic pump. About 15 years ago I had removed the remote lines on my IH 650-D. When I started it up in spring, I had no hydraulics or PS. Someone told me you might need to prime the pump by putting a few lbs. of air in the system. So I took my air compressor...
  13. A

    Drag Harrow

    I still use a 16 ft. hydraulic lift IH 401 drag harrow on my hobby farm. Before most of my land was tiled, we had ditches with water ways. You could lift the harrow from the tractor when crossing them. Also, the hydraulic lift was useful to lift the harrow on the go should it clog with grass...
  14. A

    730 D electric start electrical problems

    I run two 12 volt batteries on my JD 830 electric start. In your picture you are missing the ground wire that comes off the cable that connects the two 12 volt batteries in series with the other end going to a frame ground. This is the wire that makes the lights work on 12 volts. One light is...
  15. A

    John Deere 813 plow

    I sent you a PM this evening on the 813 plow. Al
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top