Recent content by ajo

  1. A

    2510 sleeve replacement

    I"m in the process of rebuilding a 2510 gas engine. purchaced a rebuild kit . the are no instructions for the placement of the o-rings on the sleeves. the kit includes 2 flat rings and 1 round. it is and early block with no grooves and the sleeves have only 2 grooves. the upper looks like it...
  2. A

    680 ck shuttle/torque converter

    machine has never worked since i've had it. i'm thinking that the pick-up may be the issue. there was a clump of "fibers" in the screen. not covering the whole pick-up but probably enough to restict flow.
  3. A

    680 ck shuttle/torque converter

    does not load up the engine. if you rev up throttle in gear it will just barely creep. manual says pump pressure should be 140 psi +/-. i can only get about 40 psi. not sure if a faulty converter would allow pump circuit to not biuld pressure?
  4. A

    680 ck shuttle/torque converter

    I,ve got an older 680 that will not move forward or backward. the pump, valve body and torque converter were replaced by previous owner but still only builds 40psi off pump. any other ideas on where problem may be coming from? Clutches seem to be new or very good. the machine tried to move when...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top