(800) 853-2651
SHOP NOW

Recent content by AlpineMike

Yesterday's Tractor Forums
  1. A

    MF 204 Brake Springs?

    180832M1 @ 2 orange 180815M1 @ 4 Blue 180835M1 @ 8 THANKS
  2. A

    MF 204 Brake Springs?

    Brake Spring Kit? MF 204. I have the original part numbers but, can't find a site I can purchase them. Any suggestions? Thanks
  3. A

    MF200 loader cylinders

    26 inches closed and 41-1/2 inches fully extended
  4. A

    MF200 loader cylinders

    I gave you the boom cylinder,my bad. I'll measure the bucket cylinder.
  5. A

    MF200 loader cylinders

    The MF manual I have states "Either the 2-1/4 " bore or the 2-1/2" bore, double-acting type cylinder may be installed on the loader. Both sizes of the cylinders have a stroke of 31" Hope this helps.
  6. A

    MF 204 Hinge Lift Pivots for 200 loader

    Will try it today,, Thanks
  7. A

    MF 204 Hinge Lift Pivots for 200 loader

    I"m looking for 2 "Hinge Lift Pivots" for my Front Bucket. I have a 200 Loader. Part Numbers# 1400 579M1, AGCO says their discontinued. I"m still checking the Internet. I tried to post a picture but I"m not sure if it"s going to work. Part# 19.
  8. A

    MF 204 Return hose for 200 loader

    Thanks, I tried looking at AGCO but it won't show the books, it stated I need to call a dealer.
  9. A

    3pt 204 workbull

    Did you get it fixed? mine is doing the same thing. Thanks
  10. A

    MF 204 Return hose for 200 loader

    Does anyone have the part number or hose ID for the return hose for the 200 loader. Is it 1 1/2" or 1 3/4". Thanks
  11. A

    MF 204 hydro pump filter change?

    My implement slowly stop rising, I was reading up on the possible causes and it stated that maybe the pressure release valve, can the filter cause this and can they both be changed without removing the hydro pump?? thanks
  12. A

    Governor Ajustment MF 204

    Thanks for the reply.I noticed after checking it out that the 6" throttle link was missing from the throttle lever the the governor linkage. So, I need to order one. I found a universal one the internet I'm sending off for. I'll post an up-date when it comes in. This was myfather in-laws and...
  13. A

    Governor Ajustment MF 204

    Asking for info on adjusting the governor on a MF 204 gas motor. What happens is when I start the motor goes right to high RPMS.I can't lower the engine speed. I noticed the governor rod doesn't move like it's frozen. Is the rod suppose to move if the motor is off?
  14. A

    Repair Manual ?

    Hi I'm new to the forum. Can anyone suggest a good repair manual for a MF 204 with CLEAR pictures? I just returned a "Jensales" due to the very poor pictures. Or are all copies of old manuals of poor quality? Thank You
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top