(800) 853-2651
SHOP NOW

Recent content by AOOC

Yesterday's Tractor Forums
  1. A
    Expired

    Wanted Quote for tractor hauling

    Looking for a quote to haul a farmall 560, with loader. Weight about 8000.
  2. A

    Farmall 706 runs rough until warm

    Thank-you for all the responses. Background it is a 263, and during the tune-up we did not replace the coil, so I may start with this. I should go over the carb and do real soak job, which I did not do since it looked pretty clean. When starting and it begins to run rough, choking does not...
  3. A

    Farmall 706 runs rough until warm

    I have a 1963 gas Farmall 706, in good condition. No smoke, fluids kept changed, recent plugs and points, new float and needle valve in carb. My problem is that the tractor will start great, running on all cylinders and then after about three/ four minutes it starts to miss, occasional...
  4. A

    706 C-263 Cooling Circuit

    I read a lot of your comments. I also have a 706 gas with a 263, my issue is that mine starts up, begins to miss and stalls out, acts like it's out of gas. Just started happening. Friend tells me its the float or carb is getting gummed up from sitting or using bad gas. Going to look at it...
  5. A

    Dead Weight Pulling Sled

    I want to build a dead weight pulling sled and am looking for some plans or a couple of good photos of a sled to get me started. Dimensions and materials used to build a sled and how you operate one of your pulls would also be appreciated. I have seen some sleds on the forum, but wanted a little...
  6. A

    153 combine motor

    I have a Super C with a 153 in it, motor came from a 504. Runs good. Bought it a couple years ago only pulled it a couple times. I am willing to sell it if you are interested. -mike
  7. A

    Best engine oil to use?

    Nice discussion line. Very useful information.
  8. A

    Suitcase weights wanted...wheel weights for sale/trade

    Would take some of those weights off your hands. I will be coming thru there enroute to Buffalo in a couple weeks. Let me know if you still have some. (tried your phone and did not connect)
  9. A

    Hey Brad Peters or anyone with the november pull in PA

    You both talking about the 11/20 pull in Harrisburg? If so, can I get more details on the event.
  10. A

    Death of Hugh McKay

    He took a little of us with him. He will be greatly missed. Best to his family.
  11. A

    Farmall SM side shields

    Looking for a set of side shields someone made to fit a super m.
  12. A

    560 Fast Hitch Drawbar

    Lou, The swinging drawbar was a great addition to those early tractors which had a fast hitch, for example the 1954 Super C, even thou you had the u shape drawbar this tractor came with a swinging drawbar (which was great when you pulled a disk) that hooked under the belly of the tractor...
  13. A

    560 Fast Hitch Drawbar

    Thanks for the help and the advice is well taken.
  14. A

    560 Fast Hitch Drawbar

    Thanks for the reply. This fast hitch does have traction control. Research tells me it will fit but will not be as heavy. (Similar to H vs. M parts)
  15. A

    560 Fast Hitch Drawbar

    Incidentally, nice 400. Appreciate your response. The piece I am looking for is the swinging draw bar which attaches under the belly of the tractor and swings across the horseshoe. I understand from your response that there are different lengths so that the swinging drawbar which fits a 300 or...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top