Recent content by appyshoer56

  1. R

    MF202 Power steering not working when hot.

    When I first start the tractor the power steering works fine but once it gets hot it doesn't. any advice?
  2. B

    Massey Ferguson 200/200B

    My friend bought a Massey Ferguson 200 loader/crawler. We are not sure what the exact model is, 200 or 200B. It ran fine and the seller drove it up on the traler, when home it drove off the trailer then quit moving. No forward or reverse. We have been searching forums and also bought a...
  3. C

    8/30/23

    I thought I would post a picture of me and my John Deere 830 for the day 8/30
  4. D

    massey 1155 multi power slip

    Hello, I'm new here but obviously having issues with my 1975 Massey 1155. I've done a lot of digging into research on this topic and did a few tests myself without a book so far. the tractor is going to be slowly turned into a pulling tractor as time goes on. to start out i picked this...
  5. Majorman

    Sunday Steeple

    Church and Market Place in Utrect, Holland. Utrect was the coffee making centre of Holland and, on my way from The Hook to Harsewinkle in Germany, I used to pass close by the city on the autobahn. The smell of coffee early in the mornings, wafted on the breeze for many miles. In latter years the...
  6. G

    help on brake job case 480b

    Doing brake work on my case480b and I need a something to show me where seals go pictures or anything that would help me first time doing this just want to see what's what also where is best place to buy them and pads thanks for help Gary
  7. O

    D14 - steering ram disassembly (on power steering unit)

    Ok- in the final stages of a complete 14 power steering rebuild. The steering control valve and main front support are done. New seals, cleaning, etc,etc. Figured i would save what i thought was the easy part for last. Couple of snags - To take it apart, the fist conquest is to remove the rear...
  8. D

    Farmall C, 9 bolt hubs????

    Besides weld on or the $1100 hubs that are made by a few shops for Farmall C's, what other options do I have? Was told a Minnie Mo R had 9n bolt hubs that work. Does anyone have some of the MM R hubs? Any other options?
  9. C

    Clark Kent's childhood farm

    I remember my impression was that the Kent farm could have been in my neighborhood. I found this video of the place. I was off by about 500 miles, I guess. Kent Farm
  10. J

    Super A or Allis Chalmers G

    I'm curious. If you could choose one just to cultivate a garden or two, which would you choose?
  11. jd2cyl1943

    What percent of Styled John Deere B's were on steel?

    The title sums it up. :)
  12. R

    Kubota M6040

    When tractor is in 4 wheel drive, Im hearing a slight rumble in the rear end. The rumble goes away when disengaged. Anyone have a clue what my problem might be?
  13. R

    Old tractor i.d

    I have a m/H tractor serial number on steering column at dash t.o 1001.50 has m/ harris drive train and pto motor L129A600 E2op axle hubs v hf t.o501-B side transmission t.o 4024-A by brake t.o 7006 upper steering column Hf t.o3551 hood is solid fold up to put gas and water in radiator hood...
  14. C

    JD 620 starter wiring

    I was replacing my starting switch on my cranking motor on my 620 when I noticed that my new starter switch didn't have the side screw for attaching another wire like the one in the photo. When I traced this wire back, it went to the resister. I am assuming that this side screw was just another...
  15. Majorman

    Saturday Tower

    OK, so this one reaches further than any other tower I have photographed. :0) This Australian radio telescope helped with the communications during the moon landings and also with the recent asteroid diversion experiment. Saturday Tower
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top