Recent content by Arhtur Wolch

  1. A

    Wire Harness for 1949 8N with front distributor

    Thanks guys. The wires that were in the tube originally were 5 small wires plus the 4 plug wires. I bought a new harness and it is cloth wrapped and that is so thick it does not even want to fit. Nonetheless still have the plug wires that have to fit. And the whole wire harness is just to short...
  2. A

    Wire Harness for 1949 8N with front distributor

    Can anyone help me figure out why the wire harness I ordered from Davis Tractor Parts was too short? When I ran the wires through the tube, the end that goes to the starter was too short to reach it and then also too short to reach the coil. I am totally confused. Any ideas?
  3. A

    Distributor

    I have a 1949 Ford 8N and had the distributor put back together after I foolishly took it apart. But I cannot find in my manual how to set the timming for the front mount squarecan distributor. Can anyone send me some easy to understand directions how to go about setting the timing. When I...
  4. A

    ford 8n wiring diagram

    In my last post requesting a wiring diagram for a Ford 8N I was wrong. It is a 6 volt and has not been converted to 12. Also has a front mount distributor (squarecan). Sure would appreciate any help with the gauge of the wires also. Thanks
  5. A

    1949 8N 6 volt wiring diagram

    Can someone help me with an easy to read wiring schematic (with the gauge of the wires listed) for my dads 1949 8N Ford with front mount distributor(squarecan ). It is my elderly dad whos fixing on his old tractor for a parade. Thank you.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top