-
A
Question on Tire sizes
I have a tractor with 12.4-28 tires on it and I see there is a coversion tire that is 320/85 R28 Will these fit are they the same size? will they mount the same lookslike these conversion ones are radials ?- aron5
- Thread
- Replies: 4
- Forum: Tractor & Farm Talk
-
A
Rear tractor tire where
Sugestions on Rear tractor tire purchases for 12.4-28 tractor tire Prices online are all over the place.. ?- aron5
- Thread
- Replies: 17
- Forum: Tractor & Farm Talk
-
A
tractor tires who has the best price?
Need some 12.4-28 ractor tires. Who do you think has the best price?- aron5
- Thread
- Replies: 3
- Forum: Tractor & Farm Talk
-
A
Ford 2000 running problem
I f I keep the choke out 1/2 way it stalls out faster seems like it getting to much gas.... -
A
Ford 2000 running problem
Have a 1968 Ford 2000 3 cylinder has a problem after sitting all night long doesn't want to start. Replaced distributor, points, condenser, plugs, wires, cap, roter and coil. Rebuilt carberator with kit. After it gets cold does not want to start and as I keep trying it improves, what am I... -
A
Ford 2000 has me stumped starting
No its not the choke cable cause I've had the carburetor off choke is working I cna see it moving. -
A
Ford 2000 has me stumped starting
Pulled the air filter totally in fact disconnected it from the carb for now till I figure why I m not getting anything out the stack now. -
A
Ford 2000 has me stumped starting
Ford 2000 3 cylinder gas think its a 1968 model Began running very very rough blowing lots of black out in puffs, seemed to be missing. after while didn't even want to start so I Changed the plugs, cap, rotor, rebuilt carburetor, and still no start does not seem to be blowing any type of... -
A
Plug in Carb
Would the punch damage the 3 pieces sticking up or did you use a very narrow socket the same size as the outside? Cause mine may cave in the center if I use to narrow of a punch.- aron5
- Post #1
- Forum: Tractor & Farm Talk
-
A
Plug in Carb
Here is another image of the plug Im talking about: Really Freeze it?- aron5
- Post #1
- Forum: Tractor & Farm Talk
-
A
Plug in Carb
Have a Zenith Carb of a Ford 2000 rebuilding and seen a Brass plug in the bottom part of the carb. I pulled the old one out since a new one is in the kit even though it was a pain to get out had to drill it slowly then collapse the rest . How do I get the new one in with out destroying it? any...- aron5
- Thread
- Replies: 5
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy