-
A
641 Rear Rim Question
My tractor has been missing a rear hub to rim bolt since I got it about 6 months ago. I finally ordered one, but when I received it, it wouldn't fit. After looking at the rims on both sides which are the 6 loop type, I noticed that on one side the carriage bolts have a large head and the loops... -
A
641 Aftermarket gas tank
My tractor had a new aftermarket gas tank installed when I bought it. The fuel shutoff valve was leaking and the head of the brass screw was badly damaged so I decided to replace the valve. The gas tank hole for the shutoff valve is threaded and is too small for the filter screen to fit. Just... -
A
No spark from the Jubilee
Based on what you've already done, if you disconnect the high voltage lead from the coil to the center of the distributor do you get a spark from the coil? If yes, then I would suspect your distributor cap, rotor button or plug wires. If no then either your points aren't working or your coil... -
A
Ford 641 Wrong Carb
Still working trying to sort out my carb problem. Rebuilt the carb using one of the Walker kits which was easy but I have a question for anyone with knowledge of these carbs. Do all of the MS carbs have a power jet below the nozzle? According to the diagram there should be a jet, but there is... -
A
Ford 641 Wrong Carb
I hadn't gotten any responses, but I thought I'd give an update in case anyone was interested. I've decided to replace the carburetor that came on my tractor with the correct MS TSX-365. I thought about rebuilding the carb I have, but I figured that then I'd just have a better but still wrong... -
A
Ford 641 Wrong Carb
I was having trouble using my 641 with a box blade this weekend. Whenever I went up hill pulling the blade, the tractor would start to miss and backfire, then cut off. I checked all the potential ignition problems and finally narrowed it down to the carb. After I disassembled it I found the... -
A
Ford 641 3 point hitch lever
Hi, I'm new to the forum and to Ford tractors and I have a pretty simple question. The lever on my 641 3 point hitch control scrapes against the guard that it sits in when I move it up and down but only at the top and bottom of it's range. I know that there is a cork friction disk that is...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy