(800) 853-2651
SHOP NOW

Recent content by ASE guy

Yesterday's Tractor Forums
  1. A

    Professional Tractor Mechanics and Machinists for Antique Tractors

    Graduated from auto/diesel school. ASE master for 30 years. Dodge mechanic and then teacher for 22 years in an ASE accredited school. Retired. Good luck with your list.
  2. A

    advice for using a 9N to clear snow with a back blade and to have fun in winter.

    Some very good advice here. If you have deep or heavy snow, speed matters. for heavy, wet snow I plow faster and keep moving. I also don't back up with my blade down into a snow pile.
  3. A

    Is draining water / antifreeze before winter the right move?

    I would not drain the coolant out and let it sit.
  4. A

    Tractor purchase

    I have a Massey Ferguson with the Perkins 3 cylinder. In my opinion it is a very good engine. No complaints at all.
  5. A

    Trailer recommendation

    Stored indoors and it is fine now. I think I may have a few chips.
  6. A

    Trailer recommendation

    I bought a PJ 7712 a few years ago and have no complaints. Seems to be a well built trailer.
  7. A

    Exceeding Maximum Tire PSI

    If the tire isn't too old, I would not worry that much. I would be more concerned about "heavily loaded". Your GVW is also for your transmission.
  8. A

    Voltage Regulator or Generator

    Before you test anything in an electrical system on a tractor/vehicle, you must have a known good, fully charged battery. Having the right voltage does not prove it is good. Charge the battery and have it load tested (it will likely fail) then continue with diagnostics if needed.
  9. A

    Re: Massey Ferguson 65 clutch won''t release after I fixe

    When I replaced my dual clutch on my Massey MF-20 with a 3 cyl Perkins gas engine, I bought my parts here. I did have issues with the clutch fitting the flywheel, but I had to pull the clutch to ensure I would get the correct parts. I would also buy the pilot bearing and the manual if you don't...
  10. A

    Blue Smoke - Thoughts?

    I would run compression in all cylinders, and if good, give it about a cup of tranny fluid and run it pretty hard for a while as long as I had good oil pressure when hot idling.
  11. A

    Equipment/Tractor you bought you wish you had NOT!!!

    I did a starter solenoid on a 5420. tough to get to, and would you believe they use one of the smallest torx head bolts securing it to the starter.
  12. A

    Thermostat or not??

    Put one in. They establish minimum operating temperature.
  13. A

    Would You Trust This Radiator?

    I would not go with the cheapest brand. I would go with a decent brand locally that you can easily get a warranty return on if needed. The joy of a cheap price will wear off pretty quickly if you have to pull it again. 3.3/3.8 engines were a decent engine family and they worked some of the...
  14. A

    help with ring gear ford 8n

    Remember, they have a taper. If a machine shop does it, they need to know this.
  15. A

    RIP Bruce (VA) - Bruce Haynes

    Sorry to hear this. Bruce was a solid, dependable source of information on these old tractors. He will be missed.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top