(800) 853-2651
SHOP NOW

Recent content by ASNITRO

Yesterday's Tractor Forums
  1. W

    Chain Oil for a 4 electric chain saw

    I just purchased a 4 battery powered chain saw for trimming tree branches. There is no automatic or manual chain oiler. What oil would you use and how would you apple it and how often? Thanks, Bill
  2. A

    Problems starting my Ford 8N

    Thanks 92, one of the bolts is stripped and might have to be cut out. I have a front mount distributor. What resistors do I need with a front mount system? Front or Side Mount Distributor for Ford 8N If the generator or alternator is on the right side of the tractor, then the tractor has...
  3. A

    Problems starting my Ford 8N

    I finally got the tractor started and then the radiator started shooting water out of the top. I hurried up and shutdown the tractor. Now the tractor won't start again. Voltage sometimes reads at the 2 terminal resistor. I really think there is something wrong with the 4 terminal resistor, but...
  4. A

    Problems starting my Ford 8N

  5. A

    Problems starting my Ford 8N

  6. A

    Problems starting my Ford 8N

    Here is the 2 wire resistor. Right below it is a 4 terminal resistor. Also, here is the distributor/coil. Would this be a side mount or a front mount? If I had a wiring schematic and some pictures on how the suppose to be wired I would be able to figure it out, quickly. But there is so-much...
  7. A

    Problems starting my Ford 8N

    If you are doing a 12-volt conversion, it's easier to use a "12-volt" coil. That is a front coil with at least 2.5 ohms of internal resistance or a side coil with 3.25 ohms internal resistance. You can use the 6-volt coil with an additional external resistor, but most folks do not have the time...
  8. A

    Problems starting my Ford 8N

    If you are doing a 12-volt conversion, it's easier to use a "12-volt" coil. That is a front coil with at least 2.5 ohms of internal resistance or a side coil with 3.25 ohms internal resistance. You can use the 6-volt coil with an additional external resistor, but most folks do not have the time...
  9. A

    Problems starting my Ford 8N

    Dell, your going to have to speak layman terms to me. I'm just a country boy out Tennessee, and I'm not speaking your language.
  10. A

    Problems starting my Ford 8N

    Tractor has a Side distributor. There are two resistors. The two wire resistor sets on top of the resistor block. Voltage is coming out of the ignition switch going into the resistor block, but no voltage getting to the other resistor that goes to the coil...
  11. A

    Problems starting my Ford 8N

    Hello, I'm having problems getting my Ford 8n tractor to start. This tractor has been converted to a 12v system. We are getting fuel to the carbarator, and the spark plugs are getting spark. But when I checked voltage from a wire coming out of the resistor block, going into another resistor...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top