(800) 853-2651
SHOP NOW

Recent content by average jef

  1. A

    Ford 5000 remotes are hinky after loader install

    problem solved: I completely forgot SOP, better to keep your mouth shut and let them think your a fool than to open it and remove all doubt.... simple operator error. i had inadvertently opened the float knob on the remote valve. that prolly would have been just fine if i hadn't also hooked the...
  2. A

    Ford 5000 remotes are hinky after loader install

    Again, thanks Sean. That's where logic was starting to lead me. it's cold and rainy here right now so i didn't take the tractor back to the field and hook up the transport disc but i did take a long pry bar and could not get the cylinder to budge. i know that's not the same as 1,000+ lbs bearing...
  3. A

    Ford 5000 remotes are hinky after loader install

    Thanks Sean, you know what's going on here. yesterday morning i lifted a 1,000 lb water tank with the 3 pt, so yes, it can lift a load. both ports on the PB plate and the open center valve are clearly marked "PB". i'm pretty sure they are hooked up right. this morning i'm going to check the...
  4. A

    Ford 5000 remotes are hinky after loader install

    as i mentioned the remote cylinder worked perfectly prior to install of loader. thanks for the advice, i wll remove the remote cylinder and check it. the two lines that veer to the right in the picture (left on the tractor), far right is power to the loader control, to the left of that is the...
  5. A

    Ford 5000 remotes are hinky after loader install

    that's the "power beyond" line. high pressure line out of the loader control valve to all downstream hydraulics.
  6. A

    Ford 5000 remotes are hinky after loader install

    First time poster here. have read the forum for years and usually found the answer i was looking for. Thanks to all for the great information! It has saved me a lot of aggravation over the years. ok, on to my issue: just finished the install of a front end loader on the 5000 (72-SOS), farmhand...
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top