(800) 853-2651
SHOP NOW

Recent content by b.runyan

Yesterday's Tractor Forums
  1. B

    farmall h cultivators

    My e-mail is open if you would let me know if you have them and the price. Thanks, Brian
  2. B

    farmall h cultivators, need a set and how to install

    I did look through the for sale section.
  3. B

    farmall h cultivators, need a set and how to install

    Looking for a full set with all brackets, linkage, etc for a 1940 H along with directions, pictures or a manual of how to install them and set them up. Thanks
  4. B

    farmall h cultivators

    I am looking for a complete set of cultivators [front and rear] for my H, and pictures of how they install or a manual for them. I have a restored 1940 and want them for looks.
  5. B

    H still wont start.

    Check to be sure you put the venturi tube back in place. Experience counts for a lot, I took my carb off 4 times before I found tube in parts cleaner basket.
  6. B

    H WFE nuts

    If you have a Caterpillar dealer nearby they can order them.
  7. B

    H Problem

    I"m 99% done with a total restoration on a 1940 H and had almost identical problems after I rebuilt my carb. Check to be sure you put the updraft plenum tube back in and that it"s not still in the bottom of the carb. cleaner. Ask me how I know.
  8. B

    Farmall H Clutch Noise

    Watching your video, it looks like the fork holding the release bearing is twisted. If I'm not looking at it wrong, as your pushing the pedal watch the 2 prongs on the side of the bearing, the one on the rightis closer to the top of the picture than the one on the left. Let me know what you think.
  9. B

    need shut off valve

    Sorry, failed to mention this is a 1940 farmall H.
  10. B

    need shut off valve

    I know this is probably not the right place, but I'm looking for the shut off valve for the small gas tank, and need to know if the original sediment bowl had the openings opposing each other or at 90 degree angle. E-mail is open.
  11. B

    aftermarket manifold for H

    I had to drill a hole bigger also, I guess that's what we get when we buy parts that fit a H & Super H instead of made for a H only.
  12. B

    aftermarket manifold for H

    The tube is down as far as it will go.
  13. B

    aftermarket manifold for H

    Installed a new aftermarket exhaust man. and the governor control tube will not bolt up flat, it's as if the manifold is too long, anyone had this problem?
  14. B

    Help with H

    Yes, gas flow is good, tank cleaned and sealed, new sediment bowl, first time it had gas in it.
  15. B

    Help with H

    Jim, is it possible that the jet is pushing a piece of the packing up with it each time?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top