-
B
international 484
does anyone happen to have a wiring diagram of key switch I want to see if the wiring is correct before I buy a switch ?? Thanks for the replies !!- baker3
- Post #1
- Forum: Farmall, International & McCormick
-
B
international 484
anyone have a wiring diagram for the neutral safety switch ?? right now the tractor will start when I push the clutch in after it started went to push in clutch and the safety switch engaged the starter any help??- baker3
- Thread
- Replies: 4
- Forum: Farmall, International & McCormick
-
B
1958 ford 601 wont start
I had a chance to work on this evening to work on the timing have the flywheel ring on 4 degree mark. both dots lined up on front rotor button pointing to #1 will try to post pictures to give a better description just wanted to check with everyone to make sure this is right before I hit the... -
B
1958 ford 601 wont start
Anyone know what the compression should be??? intake n exhaust valves are set at 0.015 -
B
1958 ford 601 wont start
ok thanks did a compression test #1=88lbs #2=78lbs #3=70 #4=75 lbs was thinking I have a few valves not seating right the head was sent off to be cooked and checked came back and said everything was good. what should be the compression be the book I have dosent have it in it ? I have great... -
B
1958 ford 601 wont start
I have a 601 that has been overhauled timing is set at 25 deg. before tdc new carb. points, plugs, getting good spark and fuel just rebuilt bout 2 months ago and it started an ran good, til I went up a hill and came back down it backfired at bottom and shut off. found the starter locked up...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy