(800) 853-2651
SHOP NOW

Recent content by Barry Boggs

Yesterday's Tractor Forums
  1. R

    Ford Workmaster 641 Transmission

    Ford Workmaster 641 transmission issues. Since last fluids change, while in forwards and reverse, theres been knocking noises. Tractor kept jumping out of 3rd today and now, when the gear shift is in neutral, its actually moving and in gear and wont go in any gear. If I try to put in any gear it...
  2. A

    Ford 7000

    I am considering buying a 7000, it has been setting several years and the injection pump is missing. Story is someone took it off to fix and now it is lost. I know there are a couple of different pumps for this model, I do not know which pump goes with this tractor. I am going to see if I can...
  3. B

    9n ford tractor timing

    Just because I put Bruce on the email doesn't mean anyone can't tell me what I need to do. Please tell me what I need to do. Barry
  4. B

    9n ford tractor timing

    Bruce, in your instructions the problem is that when rotating the shaft CCW (as viewed from rotor side or CW as viewed from back/tang side) until the straight edge is 1/4" beyond the outside edge of the drill bit you stuck in the distributor mounting hole. I can only get as close as 3/8" from...
  5. B

    9n ford tractor timing

    I now have the distr. out and was going to set the timing per ford tractor timing instructions but in order to get things lined up as instructed the timing screw needs to move just a little more but it runs out of room to move. What can I do to correct this problem? Barry PS I hope someone...
  6. B

    9n ford tractor timing

    Thank you, I have to wait until tomorrow when I have help taking the cover off to see if it works or that I have more problems. again thank you Barry
  7. B

    9n ford tractor timing

    Maybe I worded it wrong but it is a front mounted distributor. The part that I'm referring to is kept in place with a wire ring. it's inside the part that is bolted down. Barry
  8. B

    9n ford tractor timing

    I have a 9n that I just can't seem to get timed. I made the mistake of taking the dist out and turning it with first marking it. My question is a short one: If the dist. is 180 deg. out, will it start. Runs like hell and back fires but moving the dist. does no good plus to keep it running it has...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top