(800) 853-2651
SHOP NOW

Recent content by bayoudevil

Yesterday's Tractor Forums
  1. B

    hydraulic lift goes up but wont come down

    It will drop when I tap on the hydraulic pump valve. I lift it again and it works fine far a couple of times then it sticks again. I guess I need to drop the pump and clean it? What do I clean out and what do I look for?
  2. B

    hydraulic lift goes up but wont come down

    It is a 1939 Ford 9n
  3. B

    hydraulic lift goes up but wont come down

    I have replaced the hydraulic lift piston but when it goes up it wont drop back down. Any thoughts??
  4. B

    8n Problem starting etc......

    I have the same kind of tester with an adjustable gap.
  5. B

    8n Problem starting etc......

    Thanks for all the info and patients. This thing has been giving me fits trying to figure it out. I guess it is all in all a learning process.lol
  6. B

    8n Problem starting etc......

    I have gone through all the timing issues. I have it nailed down. Now it is just keeping the thing running when I attempt to tune the carb.
  7. B

    8n Problem starting etc......

    I tried it the way you said but it did the same thing. As soon as I started turning the screw to adjust it, it would die
  8. B

    8n Problem starting etc......

    I have tried the fast idle screw adjustment but the engine dies. I reset it to two turns out and I am able to restart the tractor. When I try to adjust the carb, it dies again. Would there be a problem in the carb . It doesn't appear to be the timing. I am not getting any back fire or stumbling...
  9. B

    8n Problem starting etc......

    Ok. Here is where I am at. I can start the tractor. Checked the spark with a spark tester and have great spark. Now is where my problem starts. When I give it gas,( move the throttle), It dies. When I adjust the carburetor, It dies. It will idle great unless I mess with them. Am I over looking...
  10. B

    8n Problem starting etc......

    I will get the resistor you pictured. I do have a question on it. I noticed it has three post. I know one side is from the ignition switch, the other to the coil. What goes on the bottom post?
  11. B

    8n Problem starting etc......

    I used two different types of light testers. I used a spark tester inline with the spark plug wires and a probe light. I would move the plate until it either lite up or went out. I would turn the engine over and watch for a spark at the plug wires
  12. B

    8n Problem starting etc......

    Like I said. I spent a lot of time on this tractor. The engine itself is good. I have looked at so many different sites and manuals my head is spinning. I am willing to give you all the information I know about this. What is the difference in the two resistors?
  13. B

    8n Problem starting etc......

    I have my son turn the key as I slowly move the plate.
  14. B

    8n Problem starting etc......

    So my resistor is the wrong one? I bought from here.
  15. B

    8n Problem starting etc......

    I have checked everything I could think of. I used a voltage meter to check for voltage at distributor. I have plenty of fuel ,maybe too much. I have torn the carburetor apart about four time. Set and adjusted the float. Measured at 1/4 in. I have noticed my governor control arms are loose . I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top