-
B
57 Ford 621 engine power loss
Thanks for the info everyone, hoping to get this tractor back up running again!- beanb26
- Post #1
- Forum: Tractor & Farm Talk
-
B
57 Ford 621 engine power loss
I have a 621 Workmaster that is experiencing loss of power and backfires quite a bit. Would a new rotor and distributor help or is this possibly a larger problem with the valves? Any help would be appreciated and I thank you all in advance.- beanb26
- Thread
- Replies: 6
- Forum: Tractor & Farm Talk
-
B
621 Fuel lines
Thanks for all the info, looks as if I have found what I needed. Scott pa, wasn't able to click on your name but thanks. -
B
621 Fuel lines
Can anyone tell me what the correct size fuel line I need for my 621. I am about to purchase a new shut off valve for it but it has a 3/8" outlet and it appears that whoever had it before me did some work on it. Looks like they have put a 1/4" line on it and removed the sediment bowl. Also... -
B
What model is this
I am almost positive I am looking at the 600 series. It definitely looks like the top picture you posted without the lights. -
B
What model is this
The casting on the side of the block is 310905 with a 2 under it. I sure do appreciate all the help, wish I could post a picture or two but I guess I haven't posted enough.... -
B
Marvel Carbs
any good ideas on the best place to go for a new/rebuilt Marvel carbs? Trying to keep this one I have (TSX-765) from leaking, gas costs too much right now for that, thanks -
B
What model is this
From what I can see there are two lines of numbers, 21 on top and then I think 39643. It is a 4 cyl, 4 speed with 3 point hitch. -
B
What model is this
I am going to be using it which also means fixing it. I have been looking at the Smiths, it looks like I have a hundred series. It has the one piece axle, serial numbers are just behind the starter but having difficulties reading the numbers to figure out exactly what I have. I think it is a... -
B
What model is this
Well feel free to laugh I don't mind but I have inherited a Ford. I have been told that it is an 8N and a Jubilee and I don't think it is either. The serial number is behind the starter but it is difficult to read the numbers. I am in desperate need to rebuild or replace the old Marvel carb on...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy