(800) 853-2651
SHOP NOW

Recent content by ben ther

Yesterday's Tractor Forums
  1. B

    Valve angle for Regular Farmall

    My F20 book calls for seat and valve angle of 45 degrees and the seat width 7/64. I would think the Regular would be the same.
  2. B

    340 points setting

    If you set the points at .20 you wouldn't need a feeler gauge just a tape measure.
  3. B

    5000 inj pump simms

    try pulling out on the cold start button. Sometimes they stick in a little not letting the governor work.
  4. B

    m sputters at mid and full throttle

    Does it run better if the choke is out a little? If so then you know it's a fuel issue.
  5. B

    Farmall h 6 volt

    If you use a 12 generator and regulator rather that an alternator every thing looks original, uses the same belt and mounts. Just my preference. I always thought an alternator looks like a cobble job.
  6. B

    Farmall 300 Generator to Alternator Conversion

    Put a 12 volt generator & regulator on. Keeps it original looking and wires up the same. Just my opinion.
  7. B

    12v.

    I still think the best way to do a 12v conversion is to change your generator to 12v. Looks original and same brackets & belt fits - a lot less cobbling. I've done several M tractors this way. Just my opinion.
  8. B

    SM Carb Help Please

    If it wasn't for Crown and home made wine these things would drive us all nuts.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top