-
B
Front mount distributor
hi thanks for reply i put everything back to gether reinstalled distributor . i checked point gap and installed new gaskets . i streched the pig tail a little also . after reinstalling i have fire to the coil but no fire coming out if plug wires . the motor turns over very fast and coil has...- BERT RUSSELL
- Post #1
- Forum: Ford 9N, 2N & 8N
-
B
Front mount distributor
This message is a reply to an archived post by Bruce VA on October 12, 2008 at 19:01:29. The original subject was "Re: Front mount distributor". how do you line up the shaht with the cap on ?- BERT RUSSELL
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy