(800) 853-2651
SHOP NOW

Recent content by BHpony

Yesterday's Tractor Forums
  1. B

    tire pressure

    What tire pressure works best using firestone 12.4 x 38 4 ply. Most of the time 3500-4000# classes. I had 10 lbs in tires yesterdays morning when i checked, pressure could have went up due to heat later in the day. Drawbar length and height are where rules allow, but tires did not hoop up...
  2. B

    allis b model name removal

    burn it off with a little propane. You can not even sand some of them off.
  3. B

    Super M surging / hunting

    check manifold studs to see if tight. Some times you dont need gasket
  4. B

    hitch

    posted wrong place earlier. If you could put hitch anywhere you wanted is there a thing as to close to axle.
  5. B

    right distance

    Is there a thing as to close for your hitch to be for for best traction. To close to axle or further back for antique pulling.
  6. B

    cuts off

    Farmall 300 always has run good, but lately it cuts off sometimes. Always start back up and runs fine. I thought it was coil but changes it out and same thing. Set points didn't help. Good gas flow. Maybe condensor. What do you guys think. thanks.
  7. B

    Carried to the end

    I hope somebody is getting rich since 28 billion was giving to farmers for trade war with china
  8. B

    It's time....for another tractor survey

    Farmall H highcrop, International 1206 wheatland, Farmall 450,. Smta, Farmall c diesel.
  9. B

    Wheel color on Massey Harris 101 Junior?

    Agri supply has the paint.
  10. B

    saplings

    I consider a sapling anything that my farmall 300 can pull out. I would rather pull them out than cut off. Some of them the chain will work, if tractor won't pull I cut them off. Some of them I can not get chain to stay on that tractor is capable of pulling out.
  11. B

    saplings

    How to pull saplings out of ground. I have tried wrapping chains & nylon straps breaks hooks on straps. Chains pull off. Is there a better way to do it. thanks for yours reply
  12. B

    I voted for the Oliver 70

    I would take the Chevy II
  13. B

    crankshaft

    I am in va. thanks
  14. B

    crankshaft

    Where can I get a 8n crankshaft with main & rod bearing. No crankshaft on this site, didn't see one on Steiner's site either.
    • BHpony
    • Thread
    • Replies: 4
    • Forum: Ford
  15. B

    M-M Paint in spray

    I found it on line, but shipping cost was exoensive.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top