(800) 853-2651
SHOP NOW

Recent content by bigtom1960

Yesterday's Tractor Forums
  1. B

    Model ?

    I just got a Massey today , serial no - TO-16379. On the tag by the steering wheel and TO-7006 by the break pedal and TO-4024 stamped above the dip stick , can anyone help me out on what model and any other info on this tractor ?
  2. B

    8 N over heating problems

    My 8N is over heating pretty easy , can I remove the thermostat and it be ok ? Mainly it does this when I try to bush hog , I have just realized there is no fan shroud , could that be the problem ? I am running a 50/50 antifreeze from Wallmart
  3. B

    8N Sherman transmission

    I would like to sell the Sherman transmission but I am having trouble locating the classified area
  4. B

    8N Sherman transmission

    I am pulling out a Sherman transmission out of my 8n , it was a cable shift but the cable itself is no good , I wish to replace it with a straight shaft due to the cable problem, is there anyone that I can sell it to ?
  5. B

    8N hydro problem

    Question , I have a backhoe implement that I wish to hook up , can I connect it up to a hose connected to that port or is the pump not connected to it ?
  6. B

    8N hydro problem

    New update ! I now have the tractor up and functioning great ! Motor , tranny and hydro ! But I still have a question , under the tractor on the hydro plate is a plug protruding close to the muffler , is it for a hose to use with a implement? Or what ?
  7. B

    8N hydro problem

    I just remove the cylinder and used air and blew the piston out now my question is this Piston has three metal rings do I have to buy them or can I just use the rubber that came in the gasket set
  8. B

    8N hydro problem

    So do you think the pump itself in the bottom is ok and should I change the fluid ?
  9. B

    8N hydro problem

    I have a 8N don't know the year I bought it as is and am now to the hydro part , I took off the dipstick cover and started it up , lift will not go up , till I took off the arms then it only came up about an inch and stopped and I can push it back down with a finger , so as I said I pulled the...
  10. B

    Fast 8N question

    I pulled the shifter panel off and found my problem , the first and third control rod was corroded and frozen, after around 20 min working with it with a hammer and prybar, I got it to working great ! Now my next question is I know I have the Sherman tranny with the push/pull cable on the dash ...
  11. B

    Fast 8N question

    thank you for the fast reply I will check that in the next few days when I take the cover off
  12. B

    Fast 8N question

    well I did it ! Split it apart and changed the clutch, pressure plate and the throw out bearing , just put her back together and started it , I tried to put it in first gear and could not but it went into second great , I lifted my foot from the clutch and noticed the pedal stayed down so I...
  13. B

    Fast 8N question

    What is the Sherman I do not understand what that is
  14. B

    Fast 8N question

    That is what it looks like after I split it on the ground you can see everything I pulled out of it my concern is where the clutch bar is going from side to side it is rusted real bad , what does everyone think has anyone seen one this bad before the clutch pedal is frozen and will not move so I...
  15. B

    Fast 8N question

See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top