Recent content by bjasa

  1. B

    Motor oil for Farmall M

    Thank you for all your responses!
  2. B

    Motor oil for Farmall M

    Since non-detergent oil is hard to find. What is everybody using in their old Farmalls. I have a Farmall M that I use year around for snow removal, manure removal, and moving round bales. It has a dual 325 loader on it plus a grapple fork. In the winter it has a 1500 watt tank heater if needed.
  3. B

    7 by 36 inch rim

    Thanks 504 and old for the info I appreciate it! The rim was made by Goodyear not Firestone.
  4. B

    7 by 36 inch rim

    here are the 3 photos This post was edited by bjasa on 08/14/2022 at 05:07 pm.
  5. B

    7 by 36 inch rim

    My brother gave me this rim, it measures 7 by 36 inches and made by Firestone and has 6 mounting lugs. I seen on a couple websites that offer 8 and 9 inch widths but no 7. They also say they can fit a Farmall A or C. Can somebody tell me what it probably fits. Enclosed are 3 photos. Thanks Bob
  6. B

    tractor- best buy-worst buy

    I have a 1947 M with a Dual 325 loader with a grapple fork and added aftermarket 3 point as my best buy. On my small acreage it moves round bales and manure and anything else that you need a loader for. The old M is dependable and easy to work on. I added a 1 spool valve to my 3 spool valve to...
  7. B

    rerouted fuel line on Ford 4000

    Enclosed is a picture of the rerouted fuel line on my Ford 4000. I covered it with a heat resistant sleeve and after mowing, raking, and moving bales this week in the 90+ heat, I had no issues. Thanks to Greg1959 for posting his picture earlier, it helped me. Thanks
  8. B

    Ford 4000 vaporlock

    I like Greg's picture for rerouting the fuel line which I will have to do. I do have the same carb and sediment bulb setup as his picture. My fuel line is on the backside of the sediment bulb. I failed to mention I used some aluminum flashing around the gas line from the carb up past the...
  9. B

    Ford 4000 vaporlock

    Has anybody rerouted the fuel line on a Ford 4000 gas tractor out there? I have to keep the tank full when it is hot or it vapor locks. You literally see bubbles in the small sediment bulb by the carburetor. I do not use ethanol. The fuel line runs from the tank next to the motor by the intake...
  10. B

    What grease would work?

    Thanks guys for your responses!
  11. B

    What grease would work?

    I'm new to your discussion page, just registered this morning. I have a Ford 3 point sickle mower, model 501-1492. I'm replacing the pitman box, new bearings, seal, etc. I would like to know what grease should be used to pack those bearings.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top