(800) 853-2651
SHOP NOW

Recent content by Blubog

Yesterday's Tractor Forums
  1. B

    ford 8n voltage regulator

    it's still 6v postive ground. the wiring was bad and the regulator was missing cover the parts I replaced need it even it they worked
  2. B

    ford 8n voltage regulator

    I also just noticed my coil was hooked up wrong. previous owner had power from key going to +
  3. B

    ford 8n voltage regulator

    got a 1952 8n tring to get it to charge. I bought a new wiring harness and regulator still no charge. Is the regulator grounded to tractor or is it rubber mounted? I noticeed some are isolated. I have the regulator bolted to tractor and there is a ground wire coming from gen that I have grounded...
  4. B

    ford 8n voltage regulator

    got a 1952 8n tring to get it to charge. I bought a new wiring harness and regulator still no charge. Is the regulator grounded to tractor or is it rubber mounted? I noticeed some are rubber mounted. I have the regulator bolted to tractor and there is a ground wire coming from gen that I have...
    • Blubog
    • Thread
    • Replies: 2
    • Forum: Ford
  5. B

    farmall 200 fast hitch question

    thanks I ran out side there is a pin. now what does the linkage on the left side with the slot and hole by the break do? let your attachment tilt?
  6. B

    farmall 200 fast hitch question

    I just got a farmall 200 today it has the fast hitch with the 3pt arms. my question is how do I get my rear lift to float? I have a 6 foot disc I want to use but if it don't float won't it lift my rear wheels off the ground when I go across a dip?
  7. B

    john deere M nosiey trans normal? and 3pt conversion

    I talked to a 80 year old john deere mechinc today. He said everyone he's hear has had gear noise because they have stright cut gears.
  8. B

    john deere M nosiey trans normal? and 3pt conversion

    I think water got in through the shifter. I have already flushed the trans with diesel and used 85-140? gear oil. It's kind of a high pitch wine it changes with the speed If I'm going down a hill it changes as the speed catches up with the engine, If that makes sence. same in all gears but get...
  9. B

    john deere M nosiey trans normal? and 3pt conversion

    just got a john deere M the trans had some water in it I pulled the shifter everything looks clean no rust. Is it normal for these transmissions to be nosiey? also is the redlandhill 3pt conversion good? I have a 3pt that goes on the quick hitch looks like a work sever design. Im limited on...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top