-
B
New to me English 1937 Fordson N with beginner questions (in USA)!
Dennis, thank you for pointing me to that supplier! I'm getting frustrated with the difficulties in finding information. The great search engines keep being "helpful" by suggesting corrections to another model such as F, 9N, 2N, 8N, TO20, TO30, and F40, Major, Dexta, Super Dexta... I was able... -
B
Need Help to identify my tractor
My best guess based on squinting at the pictures provided - and it is somewhat inconsistent: EnFo = English Ford 957E-7005 = Dexta or Super Dexta (or could be a 2000 in US market, but US didn't have 3 cylinders) My Best Reading of the 4 character date code: SF6H = May 6th 1962 For the 4... -
B
New to me English 1937 Fordson N with beginner questions (in USA)!
1) Location of engine oil dipstick or oil level plug? 2) I cracked open the carburetor and found what looks to be an emulsion tube was broken off... Where to find a replacement? And some gaskets? How do I know which carburetor it is? Or am I going to have to solder it, if that is even possible... -
B
8N TSX 241 Only runs well at 1/4" Choke
Are not the intake and exhaust gasket the same? -
B
8N TSX 241 Only runs well at 1/4" Choke
Spark is very good, so I don't think that is the issue. -
B
8N TSX 241 Only runs well at 1/4" Choke
So I had the carburetor off and on that tractor 4 or 5 times this afternoon. Still can't get it to run well under load unless the choke is out. I even tried another carburetor kit. So, thinking outside the carburetor, could it be timing or the governor, or something else? Other things I looked... -
B
8N TSX 241 Only runs well at 1/4" Choke
I got exactly 20 floz in 2 minutes! Tearing back into the carb.... -
B
8N TSX 241 Only runs well at 1/4" Choke
I'm game to pull it and try to get all the passages cleaned (I'm surprised the chemical bath didn't get to it because it was so clean I would have eaten off of it). Is there some document that enumerates all the passages and best wire sizes? -
B
8N TSX 241 Only runs well at 1/4" Choke
I have an original cast MS TSX on my 8N. I have chemical dunked it, rebuilt it, but for the life of me, can't get it to run well unless I hold the choke out about 1/4" (and I mowed the field for an hour with a vice grip holding the choke out, so it has had plenty of time to "warm up"). I've... -
B
Can anyone ID these rims?
I did some digging and found that later on, DC-303K 224-D12 Geneva Pressed Steel wheel rims were use. Maybe the same supplier provided the earlier wheels as pictured too? Any catalog potentially exists or something?- bmoran4
- Post #1
- Forum: Garden Tractors
-
B
Troubleshooting Fairbanks-Morse FMJ Magneto
Just out of curiosity, can something like a STENS MEGA FIRE be fitted to these magnetos?- bmoran4
- Post #1
- Forum: Garden Tractors
-
B
Troubleshooting Fairbanks-Morse FMJ Magneto
Found a big book 4 inches thick for the FM Mags (much more than $20, that's for sure) and it only had one page on behind the FM-H, J, K, O, OH separator tab - how to perform a rotation changeover with a kit. Other mentions throughout of the FM-J series show it to be obsoleted. Thankfully, this...- bmoran4
- Post #1
- Forum: Garden Tractors
-
B
Can anyone ID these rims?
Early Baird and Springfield lawn tractors.- bmoran4
- Post #1
- Forum: Garden Tractors
-
B
Can anyone ID these rims?
I am aware of the single piece "wheelbarrow and lawn trailer" replacement wheels available from Tractor Supply, Harbor Freight, and similar... I'm looking for these exact style multiple piece rims with the center hub setup as pictured. It is a 3/4 bore on the hub.- bmoran4
- Post #1
- Forum: Garden Tractors
-
B
Can anyone ID these rims?
Obviously, I am in need of a source for these 4 inch wide, 8 inch diameter rims for the 4.80-8 tube tires. Any ID on manufacturer, style, or other helpful direction to find a source?- bmoran4
- Thread
- Replies: 7
- Forum: Garden Tractors
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy