(800) 853-2651
SHOP NOW

Recent content by Bob LaBrie

Yesterday's Tractor Forums
  1. B

    hand crank compatability for Pacer

    Interesting... ok thanks Wayne. So I have two ideas. 1.) Last I checked, a concrete forming stake was 3/4" diameter and has holes drilled around the circumference at different locations to accommodate those double headed nails. I could loop off the tapered end 1/2 inch from the center...
  2. B

    hand crank compatability for Pacer

    Incredibly detailed Wayne. Thank you. That's exactly what I was looking for. it never occurred to me that the pin was by design to be at 45 degrees in that position. I wonder why that is... design or random? This is awesome. Thank you for taking the time. Bob I was about to pull the...
  3. B

    hand crank compatability for Pacer

    Thanks smoke. Can you measure the crank and it's bends... and maybe estimate how much too long it is so I cold look at making one. For pin, Whats the diameter and how long is the pin? Bob
  4. B

    hand crank compatability for Pacer

    Appreciate that, yeah but where can I get one. I only see cranks on ebay for Fird or IH and they call out compatibility fit some MF's but I need to know the dimensions of the Pacer crank. Like each bend Any idea where I can get one.. Or if I make one, what are bends and what diameter...
  5. B

    hand crank compatability for Pacer

    My No. 16 1955 Pacer has a crank shaft jaw nut that will accept a hand crank, however I can't seem to find a hand crank for sale that will fit my Pacer. Some of the Ford and IH hand cranks on ebay look like they would fit, but am not 100% sure. Any ideas what the dimensions are for a hand...
  6. S

    J d 520

    Need some advice. My 520 sat for a year. The set. bowl was leaking oil. I repaired the diafram in the bowl for the auto shut off. I pulled the set. bowl out of the tank and drained all of the old gas out of the tank. Changed oil and filter put 2 quarts gas in tank it started right up.Didnt idle...
  7. B

    PACER side panel fabrication

    I recall reading a "how to" page regarding fabrication of M-H Pacer sheet metal side panels. I cannot find that page. Any idea where that is located. I need left side panel for Pacer and am considering building one. Thanks, Bob
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top