-
B
Ole John
I started up 'Ole John' today after about 2 months, I have had this guy since 1971. Took two 'Rhumpas' to start, BUT, It took 45 mins. to get up to 140 degrees temp. Not really worried, it was 5C in the shop. BUT (again) I couldn't get over the '0' in 140. This thing has shutters ( that I...- Bob Harvey
- Post #1
- Forum: John Deere
-
B
Aluminum flat back
Hi i am looking for a aluminum flat back for a 1951 john deere A does anyone have one around or know were i could get one- Bobfog
- Thread
- Replies: 8
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy