(800) 853-2651
SHOP NOW

Recent content by bobrobert58

Yesterday's Tractor Forums
  1. B

    Ford 641 Flooding

    Thank you all for the advice! I had cleaned and installed a new carb. kit with no change. I will check the oil bath air cleaner and also check the plugs and timing. Again, thank you all for the most helpful comments.
  2. B

    Ford 641 Flooding

    I have a ford 641 gas tractor and need some help. It is hard to start and very easy to flood if chocked at all. When using the choke you will get gas running out of the carburetor intake if the hose is removed. when I do get it started it will settle down and run ok but he governor rod will...
  3. B

    Case IH 2294 Tractor

    Thank all of you for the great input. I appreciate it greatly!! Bob
  4. B

    Case IH 2294 Tractor

    He thinks it has a "clunking" noise when turning, I've never noticed any.
  5. B

    Case IH 2294 Tractor

    Just a few additions for clarity. When I do use the diff. lock I bump the brakes and turn it off before turning on the ends...obesely. This all started when I took the tractor in for another issue and they came up with the idea of needing to "open it up" for inspection. I have never had any...
  6. B

    Case IH 2294 Tractor

    It was news to me as well and I'm not sure I agree with his recommendation. In the past I have only used it when using hard pulling tillage tools. I have a Trimble Auto Steer on it that I use when spraying and I think the diff. lock and Trimble would be fighting each other. He feels that I've...
  7. B

    Case IH 2294 Tractor

    I have a 2294 that I use in my farming operation. I have been told by a Case IH service tech that the differential lock should always be engaged when the tractor is used in any field operation and not doing so will destroy the spider gears in the rear end. I have used the tractor for several...
  8. B

    Ford 641 Flooding

    I have a 641 tractor that likes to flood when starting. I've used very little choke and it will flood bad enough that gas will run out of the carbonator. It is very difficult to start. when it gets running and warms up it's fine. I checked the float level and cleaned the Crab. and it made no...
  9. B

    ford 641 Idle speed

    I have a 641 that's unable to idle below 800 rpm. When it gets below 800 it will stall out. I did cleaned the carb. and set the float in an attempt to help with easy flooding when starting. It still floods easy and now has developed the poor idle problem Any ideas?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top