Recent content by bobruffner

  1. B

    How do you get the pulley off a B?

    If I have the pto lever pulled up (engage pto) and the transmission in first shouldn't the belt pulley shaft be connected to the rear drives and tires and prevent the belt pulley shaft from turning?
  2. B

    How do you get the pulley off a B?

    I'm trying to get the belt pulley off so I can put on a Woods mower pulley. I can't get the nut loose, the shaft and pto spin even when I have it in gear. Any help?
  3. B

    Sorry..another O/T (case of the stupids)

    Joe's rate is 1 field per 4 hours = 1/4. Frank's rate is 1 field per 6 hours. Let t= time it takes for both of them to plow 2 field. 1/4t + 1/6t = 1 field. 6/24t + 4/24t = 1 10/24t = 1 t = 2.4 hours = 2 hours 24 mins.
  4. B

    air compressor in unheated garage with copper lines

    I'm thinking about putting a large air compressor in an unheated garage here in Michigan where it stays below freezing for long periods of time. I also was looking at 3/4inch copper lines. Is this a bad idea given the cold and freeze / thaw cycles?
  5. B

    2 man post hole digger

    I've rented the 2 man in the past and it is an incredible amount of work and really heavy to pull up to clear the hole. I really recommend a small trailer mounted auger especially for 12inch holes if you can get the trailer to the site (it's not real big). Home Depot rents them along with the...
  6. B

    Ross vs Gemmer steering gear on an Allis B

    How can you tell if it is Ross or Gemmer steering gear on an Allis B, what are the differences?
  7. B

    Allis B rear axle oil seal part number

    Does anybody have the part number for the rear axle oil seal for the older style final drive (single nut, not the 5 bolt design) that is replaced from the outside? Does replacing this seal usually stop oil leaks or are there usually other problems? Thank you.
  8. B

    JK I posted Allis B snow plow pictures in Implement Photos

    Take a look at the photos, let me know if you need any measurements. It's a nice set-up because it uses the original hydraulic ram and rock shaft instead of having to run hydraulic lines to the front of the tractor.
  9. B

    Allis B air out of crankcase / water in oil

    Thank you all for the responses, it sounds like I wasn"t letting the engine get warm enough during the cold months. I have radiator shutters on the tractor but they are frozen / rusted in the open position. After the water in the oil was found I put a Hefty garbage bag over the front grill to...
  10. B

    Allis B air out of crankcase / water in oil

    I have an Allis B with a snow plow blade, I changed the oil right before winter (10W-30 with detergent). It was really cold in MI this Dec and Jan, we got a lot of snow, I was plowing almost every morning for 4 weeks in 0 to 10F weather about 1/2 hr. I checked the oil in Feb and found water in...
  11. B

    Allis B transmission or rear end grinding noise

    Im looking at an older B (39 I think) that has a grinding noise in 1st and reverse gears - 2nd and 3rd are ok. Is this a big concern, if a fix is needed is it easy? I dont have a lot of experience with this tractor. Other Bs I have driven did not make this noise. Thanks.
  12. B

    Will a CA wide front work on a C?

    Will the adjustable wide front from a CA bolt on to a C without any modifications?
  13. B

    Allis B air cleaner oil

    How much oil should go into the removable oil cup at the bottom of the air cleaner? Does it also go into the center cup that the center tube fits into? There are 3 holes in the side of this center cup, is the oil supposed to be above or below these holes? What viscosity oil?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top