Recent content by bpark3

  1. B

    Helping your kids???

    JD Seller. I must commend you for the way you have offered this boy a leg up. The help is there but he must earn it. Our boys were raised the same way but they always knew I was there to back them up if they genuinely needed a leg up. I do believe though that the boys dad did raise him with good...
  2. B

    Timing WC

    Hi Don, here ya go. This should get you there. Bob http://home.comcast.net/~old_allis/ac-wc-mag-timing.html
  3. B

    Small town festivities (pics)

    Very nice pictures. Thanks for posting! Bob
  4. B

    f 12 that dont want to start

    Hi Don, I tried to tow my F-12 a few years ago after I finished working on it and painting it. The results weren't good. I did ruin the clutch and had to replace the clutch disk. Use caution there. Just saying. Bob
  5. B

    ford 8n oilchanges

    Fred, at this point, the best investment you can make is an owners manual and or an FO-4 service manual both readily available on this site or many others. Bob
  6. B

    4th of July

    FBH44 I worked for Harvester back in the 50's and remember these air cleaners being sold as an accessory by dealers, they were an after market brand. I don't remember the name, and the old decals are long gone. they worked well as I remember. I have a Case SC with one of these on it as well.
  7. B

    4th of July

    My Grandson on the "H" in the 4th of July parade 2014, Miles City, Mt
  8. B

    New Holland skid steer

    going to an auction Saturday to look at an L779 New Holland skid steer with a perkins engine. supposed to be in operating condition. any comments on this unit. have never operated this model before. Thanks, Bob
  9. B

    Skid steer loader

    Going to an auction Saturday to look at a New Holland 779 skid steer, has a perkins diesel engine. Any comments? thanks Bob
  10. B

    Super A pull type mower.

    Woodby, under some conditions it would be a load for the 'H' , so doubt if the super 'A' could handle it unless trimming short grass. just my input. regards, Bob
  11. B

    PTO seal

    ken, remove the seal retainer and drive out the old seal which was a thick 2 piece seal consisting of an oil seal and a dust seal. no longer available, so use to narrow oil seals instead. install one facing towards the rear end to seal the oil in, and the other facing out to prevent dust from...
  12. B

    Best way to sharpen the blade on an AC 160 mower?

    hi Will. should be one long blade with flexible tips. to sharpen mine, i stand it on it"s rear end by the hitch with a front end loader and use a 4 1/2" angle grinder. this old guy would rather stand up than lay down. regards, bob
  13. B

    Allis D19

    leeallen, try this link Untitled URL Link
  14. B

    still working here

    casenutty, i am an old farmer and have been off the land for quite a few years. i can't tell you how much i look forward to seeing the pictures you post on this forum. they brighten my day. i always loved the old case machinery and tractors. i am up at miles city. are you around gillette? bob
  15. B

    Don't see this much any more - Pics

    nice, nice, nice. thanks for posting
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top