(800) 853-2651
SHOP NOW

Recent content by BraydonIH240

Yesterday's Tractor Forums
  1. B

    240 hydraulic levers and Superior H-228, Help Needed

    As I recall I bought a 3-lever set off a 460 or 560, and I may have some parts left. If I have what you need we can get together via email and I'll send it to you. That would be Great! Thank you very much
  2. B

    240 hydraulic levers and Superior H-228, Help Needed

    OK, Can anyone tell me which lever will fit? It looks like the spline OD max is approximately 1.04" and the min is approximately 0.970. Someone please chime in but I think I'm only suppose to have one lever up front. There are 2 valves on the tractor and I have a lever on the right side of...
  3. B

    Superior H-228, Help Needed

    I'm still looking. Anyone have any input? thank you
  4. B

    240 hydraulic levers and Superior H-228, Help Needed

    Janicholson- Thanks for th tip about the single/double acting selector. I knew it was there but I haven't checked to make sure it was all the way to double. a_lead- I have no doubts that this machine has been pieced together over the years. I can add some stops to the side seat lever to...
  5. B

    240 hydraulic levers and Superior H-228, Help Needed

    Thank you for the reply. It is difficult to figure out the issues when I can't seem to find a good explanation of which lever does what. The lever on the side of the seat is very "picky" as to the position it is in. Too far in either direction and it keeps a load on the engine/pump and I do...
  6. B

    240 hydraulic levers and Superior H-228, Help Needed

    The Splines are actually OK, they are just covered in old grease.
  7. B

    240 hydraulic levers and Superior H-228, Help Needed

    I already tried to rotate the splined shaft. It moves freely. It will raise and lower the 3 point extremely slowly and return to center when the 3 point is fully raised or lowered. I also have a lever on my right side (while seated on the tractor) that will raise and lower the 3 point very...
  8. B

    240 hydraulic levers and Superior H-228, Help Needed

    I've been searching everywhere and I cannot come up with anything (manuals, parts, specs, etc...) for an H-228-I that I have mounted in an IH240. Does anyone have anything they can bring to the table? Any help would be appreciated. I am also looking for the hydra touch levers and "linkage"...
  9. B

    Superior H-228, Help Needed

    No one has any information on a Superior Front end loader??? I can share some IH 240 manuals...
  10. B

    Superior H-228, Help Needed

    Anyone have any information??
  11. B

    Superior H-228, Help Needed

    I've been searching everywhere and I cannot come up with anything (manuals, parts, specs, etc...) for an H-228-I that I have mounted in an IH240. Does anyone have anything they can bring to the table? Any help would be appreciated. Thank you
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top