(800) 853-2651
SHOP NOW

Recent content by Brian Williams

Yesterday's Tractor Forums
  1. B

    Has this carb been brazed? Dltx71

    It certainly appears that it has been repaired. At least that?s my vote .
  2. B

    Farmall oil filter

    I have one on my model H. I had to modify it because the hole in the adapter for the filter was way too big and allowed it to bypass too much which lowered the oil pressure substantially. I just tapped it put a plug in it and drilled a small hole in the plug comparable to the size of the...
  3. B

    Low radiator G

    No cutout for steering shaft on low radiator G.
  4. B

    47 A no oil pressure

    You?re Tractor will run with no oil pressure even if there is no filter in there. With that being said, the only two things that I can think of that would cause no oil pressure is: is sheared off drive shaft coupling or a badly distorted filter housing created by over tightening the filter nut...
  5. B

    Right off the farm Oliver 77 RC

    I kind of feel silly asking this question due to the fact that I?ve been around tractors my whole life and been to many tractor pulls. I just bought a right off the farm Oliver 77. I?ve wanted one for a long time because when I was a child we had a 77 on the farm. When we sold the farm the...
  6. B

    Decals

    I installed vinyl decals on a John Deere A back in 1996. I still have the tractor and the die cut decals look like brand new. Depends on who you buy them from.
  7. B

    F12 Road gear / overdrive

    How rare or common are the high speed gears for the F 12 tractors? I would like to find either the road gears or auxiliary overdrive box Heiser / Behlen or both. Where is a good source for either of these? Brian
  8. B

    Oliver 77 main beaings

    I went to Korves website. Awesome nice to know where to get parts when I need them maybe.
  9. B

    Oliver 77 main beaings

    I have a 1950 Oliver 77 that I am searching for main bearings for. I have the Clevite number but no one can seem to cross it to anything else. Trying Napa but not a lot of success. I have two questions. Are the bearings from an 88 the same as a 77? And does anyone have the part number...
  10. B

    Ford 9N no oil pressure

    This is probably the wrong forum for this. But I had this issue with a little Ford tractor one time. I had to take the pressure relief valve plug out of the front of the engine and put a funnel and hose in it and add oil in to that hole which will make it run down into the pump gears and...
  11. B

    F12 carburetor

    I am betting that he drilled a passage and screwed it up. I want to try to figure it out. Hate to throw a nice shiny brass carburetor in the trash you know.
  12. B

    F12 carburetor

    I just purchased a 1936 F 12. It has a brass carburetor. I put new rings and had the head redone. You can barely get it to start and when it does it idles like a Top fuel dragster. In the other words it misses more than it fires at idle and middle RPMs. It will run wide open fairly decent and...
  13. B

    Jd 2010 diesel

    I agree they are one of if not the worst tractor they ever came up with. I had a 2010 industrial diesel. Was the best starting diesel engine I think I ever had if using the glow plugs for 30 seconds or so. Way better than a 2 cylinder Kubota diesel I had. That being said I don?t think you could...
  14. B

    Plow for Model M

    . Looks like you need to move the plow to the left. Definitely on the other side of the ears on the hitch plate. My book shows the same hitch plate as the M-1 plow.
  15. B

    Farmall H hand clutch

    Are there any interchangeable parts between the Hand clutch for the model H and the M? Could my 1951 H have M components? If so that would make a great unit for it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top