-
C
Tractor size for square baling?
Even got steel wheels- Calfmaster24
- Post #21
- Forum: Tractor & Farm Talk
-
C
Tractor size for square baling?
- Calfmaster24
- Post #20
- Forum: Tractor & Farm Talk
-
C
Tractor size for square baling?
I make hay on 3.5 acres and used a ford 8n. Which I had to use an Amish baler since the N didn't have a live pto. It worked great cause I could make hay in any gear with the tractor at an idle if I wanted! Another downside was the tractor isn't heavy and felt loose once the wagon got full. My...- Calfmaster24
- Post #17
- Forum: Tractor & Farm Talk
-
C
641 workmaster
I'd also like to install a foot throttle since there is a loader on it. Anyone know where to find such a thing?- Calfmaster24
- Post #3
- Forum: Tractor & Farm Talk
-
C
641 workmaster
Good day! Recently bought the 641 but I'm not very familiar with this new breed! So far I have two questions. One: it will pop out of 4th gear. It stays in for a little then it just pops right out! Almost like it doesn't go in as deep as other gears? Two: oil pressure reads 80+ even after warmed...- Calfmaster24
- Thread
- Replies: 7
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy