-
C
OC3 Final Drive Seal
Can anyone confirm the large final drive seal size of 146x168x17?- Carsten S
- Thread
- Replies: 4
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
C
Oliver OC 3 Engine Work
Update: Compression tested 100-120 psi. 1/4” of sludge in the oil pan. I decided to go for it and pulled the head and the pistons out. The pistons and rings all look quite good actually. It appears to have been burning oil for some time based on the build up. When looking at the valves it...- Carsten S
- Post #7
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
C
Oliver OC 3 Engine Work
Thanks Everyone, I will check the compression first and go from there.- Carsten S
- Post #6
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
C
Oliver OC 3 Engine Work
I just picked up a OC-3. It is in decent condition, but it is a smoker! It uses a quart of oil pretty quickly (1-2hrs) and isn t leaking it. This is my first time getting into fixing tractors, but have done a lot of motor work, mostly motorcycles. My question is, where would an experienced...- Carsten S
- Thread
- Replies: 7
- Forum: Oliver, Cletrac, Co-op and Cockshutt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy