(800) 853-2651
SHOP NOW

Recent content by Case450

Yesterday's Tractor Forums
  1. C

    I dont know what this is but it leaks hyd oil case 450 crawler loader

    Only found o rings where the hydraulic lines enter the valve body but its leaking where the plunger shaft exits the valve body, I threw an o-ring onto that plunger shaft and it did nothing to slow the leak. Im assuming I have wrong size o rings???
  2. C

    I dont know what this is but it leaks hyd oil case 450 crawler loader

    I changed the one o ring on the cap, the old one seemed fine but when i reinstalled and tested it's leaking around that plunger/shaft. I'll remove and disassemble further and try 'er out.
  3. C

    I dont know what this is but it leaks hyd oil case 450 crawler loader

  4. C

    I dont know what this is but it leaks hyd oil case 450 crawler loader

    Case 450B crawler loader. I think this is a bucket leveling valve? It leaks pretty bad, is this something I can repair with some o rings or would a hydraulic cylinder shop be better to do it? I dont even really know what it is tbh
  5. C

    Case450B track pad bolts spinning

    How the heck do i keep the track pad nuts from spinning when trying to tighten a few loose track pad bolts? I can't get a 3/4 inch wrench inside the track chain onto the nuts, i tried a large crescent wrench.....actually maybe a shim might work....maybe i'll jam a shim in between the track pad...
  6. C

    Fuel leak 1990 case 580 backhoe cummins

    Fuel is leaking from where the throttle linkage attaches to the motor. There's a tab with a spring under the linkage lever and under there is where fuel is leaking. I assume there's an o ring or something that seals that shaft so my question is how would I go about that repair without affecting...
  7. F

    steering Cylinder on a MF50D backhoe

    My cylinder is leaking and I need to rebuild it. I got every thing loose except for the bolt on the cylinder. Hope I can post picture to show what I need to get loose and how <video width=90% src=https://www.yesterdaystractors.com/cvvideos/cvvideo158771.mov...
  8. C

    Kohler command pro CRANK NO START

    I can't seeem to find much helpful info on the web and this is a last resort post lol I have a timberking 2000 sawmill with a kohler command pro CH940-CH1000 gas motor with a crank no start issue. I've pulled the spark plugs and they are both wet. I've removed a plug and held it to the block to...
  9. C

    Case 580 ck TLB neutral button on loader stick

    The button on top of my 1994?? Case 580 backhoe loader control lever popped off and now the doggone machine stays in neutral. How can I hotwire/bypass that button so I can use the machine again? I never used that button before anyways
  10. C

    2018 jd 750 xlt dozer auction buy no key

    Yeah I'm sure the dealer will have something but I'm just anxious to see if it runs right if it runs at all. It was labeled as salvage
  11. C

    2018 jd 750 xlt dozer auction buy no key

    I just bought a 2018 john deere 750k xlt dozer at the auction and it has no keys. Is there a way I can start it to see if it even runs? The fluids and the filters look good, undercarriage is about 50%, glass is cracked some dents and scratches. Local dealer is closed until Tuesday.
  12. C

    Case 580 ck slow cranking

    I been having a hard time getting my backhoe to crank proper. It cranks slow like the batteries are weak. I replaced all the cables (its 2 - 12 volt batteries in parallel) and tried 2 new oversize batteries just to crank it and it still cranks super slow. Like wont start slow. Time to rebuild...
  13. C

    Cav rotary pump removal/MF470 WHEEL LOADER

  14. C

    Cav rotary pump removal/MF470 WHEEL LOADER

    I was told not to remove the pump from my old as dirt MF 470 Wheel loader w/perkins diesel because the removal might alter the timing of the pump. I've had a mobile mechanic (who has since passed) install a rebuild kit with the pump in place. I am not entirely sure what is involved with...
  15. C

    Case 580 seems to slip in and out of gear

    AJ yeah you right it jumps out of gear but the shifter stays in place. I will check the fuses tomorrow.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top